Skip to contentSkip to conversation

Neep help with my MMC driver ...

DISCUSSION Pierre Ossman 2 participants 2 messages Jul 20, 2007 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): 000c01c7cad4$127dcba0$377962e0$@[email protected]

#1 lore raw
Quoted 6 lines · On Fri, 20 Jul 2007 15:44:18 +0200 "Pierre Savary" <[email protected]>…

Hi,

I permit me to send you a mail because I've seen on the net that you have work around MMC.

Well, I am the maintainer ;)

Also, you should include the LKML for these discussions.

Quoted 6 lines

Linux 2.6.21+patch.AT91 run on my AT91sam9260. I must use the MMC. But it doesn't work . and I try since the begin of this week !!!!!!!! This is what I do :

*snip*

Quoted 3 lines
$ mknod /dev/mmc b 254 0

Make sure this is the correct major. You can find it in /proc/devices.

*snip*

Quoted 14 lines

Sending command 1 as 00001041, arg = 00000000, blocks = 0, length = 0 (MR = 00008384)

setting ier to 00000001

MCI irq: status = 0001C0E4, C07F0001, 00010000

MMC: Response index error

Completed command

Status = 0009C0E4 [00000000 00000000 00000000 00000000]

Quoted 8 lines

Error detected and set to 4 (cmd = 1, retries = 0)

mmc0: req done (CMD1): 4/0/0: 00000000 00000000 00000000 00000000

mmc0: clock 0Hz busmode 1 powermode 0 cs 0 Vdd 0 width 0 timing 0

MMC: Setting controller bus width to 1

All your commands are failing, oddly enough with "response index error". I'm not familiar with the AT91 controller, so I'm adding Nicolas Ferre, the AT91 maintainer, to this discussion.

Rgds

Signature · 5 lines
     -- Pierre Ossman

  Linux kernel, MMC maintainer        http://www.kernel.org
  PulseAudio, core developer          http://pulseaudio.org
  rdesktop, core developer          http://www.rdesktop.org
#2 lore raw

Pierre Ossman :

Quoted 7 lines
Quoted 4 lines · On Fri, 20 Jul 2007 15:44:18 +0200 "Pierre Savary" <[email protected]>…

Hi,

Quoted 10 lines
Quoted 2 lines

I permit me to send you a mail because I've seen on the net that you have work around MMC.

Well, I am the maintainer ;)

Also, you should include the LKML for these discussions.

Quoted 3 lines

Linux 2.6.21+patch.AT91 run on my AT91sam9260. I must use the MMC. But it doesn't work . and I try since the begin of this week !!!!!!!! This is what I do :

Please use the very last patchset developed those last days for at91_mci.

Regards,

Signature · 1 line
Nicolas Ferre