Skip to contentSkip to conversation

dmascc ?

DISCUSSION Niall Parker 3 participants 4 messages Nov 12, 2007 – Nov 15, 2007

lore
Share & tools
lore
#0 lore raw

Hello,

It's been a while since I've tried a new kernel with my PI2 cards and just discovered that while the source is still included in drivers/net/hamradio/dmascc.c , it isn't possible to select via make menuconfig even when CONFIG_EXPERIMENTAL is set.

I hunted through the linux-hams archives and it looks like the code is still being updated, is there some other reason why dmascc is no longer a config option ?

					... Niall
#1 lore raw
Quoted 8 lines · Niall Parker

It's been a while since I've tried a new kernel with my PI2 cards and just discovered that while the source is still included in drivers/net/hamradio/dmascc.c , it isn't possible to select via make menuconfig even when CONFIG_EXPERIMENTAL is set.

I hunted through the linux-hams archives and it looks like the code is still being updated, is there some other reason why dmascc is no longer a config option ?

You can only configure the driver when building a uniprocessor kernel for an ISA system and AX25 must also be enabled. Even an oldfashioned hyperthreaded P4 needs an SMP kernel these days so this driver is hardly being offered anymore and I guess that's the problem you're having.

Ralf

73 de DL5RB op Ralf

--
Loc. JN47BS / CQ 14 / ITU 28 / DOK A21
Packet: DL5RB@DB0FHN.#BAY.DEU.EU

#2 lore raw

Hi,

Is an SMP kernel mandatory for running a multithreaded P4 CPU or would'not a single CPU kernel make it (with a 50% performance reduction) ?

73 de bernard, f6bvp

Quoted 24 lines · Ralf Baechle DL5RB wrote:
Quoted 3 lines · Niall Parker

It's been a while since I've tried a new kernel with my PI2 cards and just discovered that while the source is still included in drivers/net/hamradio/dmascc.c , it isn't possible to select via make menuconfig even when CONFIG_EXPERIMENTAL is set.

I hunted through the linux-hams archives and it looks like the code is still being updated, is there some other reason why dmascc is no longer a config option ?

You can only configure the driver when building a uniprocessor kernel for an ISA system and AX25 must also be enabled. Even an oldfashioned hyperthreaded P4 needs an SMP kernel these days so this driver is hardly being offered anymore and I guess that's the problem you're having.

Ralf

73 de DL5RB op Ralf

--
Loc. JN47BS / CQ 14 / ITU 28 / DOK A21
Packet: DL5RB@DB0FHN.#BAY.DEU.EU
-
To unsubscribe from this list: send the line "unsubscribe linux-hams" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

#3 lore raw
Quoted 2 lines · Bernard Pidoux

Is an SMP kernel mandatory for running a multithreaded P4 CPU or would'not a single CPU kernel make it (with a 50% performance reduction) ?

The performance benefit or even if there's one at all depends very much on what generation of P4 you're using and many more factors, but yes, if you want to realize that gain you will need to enable CONFIG_SMP or hyperthreading is just going to be a few square milimeters of wasted silicon.

Ralf