regulator: regulator framework build.
PATCH 5/6 regulator: regulator framework build.
This patch adds support to build the regulator core.
Signed-off-by Liam Girdwood <[email protected]>
--- drivers/Kconfig | 2 ++ drivers/Makefile | 1 + drivers/regulator/Kconfig | 32 ++++++++++++++++++++++++++++++++ drivers/regulator/Makefile | 9 +++++++++ 4 files changed, 44 insertions(+), 0 deletions(-) create mode 100644 drivers/regulator/Kconfig create mode 100644 drivers/regulator/Makefile
drivers/Kconfig +2 -0
@@ -62,6 +62,8 @@ source "drivers/hwmon/Kconfig" source "drivers/thermal/Kconfig" +source "drivers/regulator/Kconfig" + source "drivers/watchdog/Kconfig" source "drivers/ssb/Kconfig"
drivers/Makefile +1 -0
@@ -66,6 +66,7 @@ obj-$(CONFIG_W1) += w1/ obj-$(CONFIG_POWER_SUPPLY) += power/ obj-$(CONFIG_HWMON) += hwmon/ obj-$(CONFIG_THERMAL) += thermal/ +obj-$(CONFIG_REGULATOR) += regulator/ obj-$(CONFIG_WATCHDOG) += watchdog/ obj-$(CONFIG_PHONE) += telephony/ obj-$(CONFIG_MD) += md/
drivers/regulator/Kconfig new file +32 -0
@@ -0,0 +1,32 @@ +menu "Voltage and Current regulators" + +config REGULATOR + bool "Voltage and Current Regulator Support" + default n + help + Generic Voltage and Current Regulator support. + + This framework is designed to provide a generic interface to voltage + and current regulators within the Linux kernel. It's intended to + provide voltage and current control to client or consumer drivers and + also provide status information to user space applications through a + sysfs interface. + + The intention is to allow systems to dynamically control regulator + output in order to save power and prolong battery life. This applies + to both voltage regulators (where voltage output is controllable) and + current sinks (where current output is controllable). + + This framework safely compiles out if not selected so that client + drivers can still be used in systems with no software controllable + regulators. + + If unsure, say no. + +config REGULATOR_DEBUG + bool "Regulator debug support" + depends on REGULATOR + help + Say yes here to enable debugging support. + +endmenu
drivers/regulator/Makefile new file +9 -0
@@ -0,0 +1,9 @@ +# +# Makefile for regulator drivers. +# + +obj-$(CONFIG_REGULATOR) += reg-core.o + +ifeq ($(CONFIG_REGULATOR_DEBUG),y) + EXTRA_CFLAGS += -DDEBUG +endif
Signature · 1 line
1.5.4.2
drivers/regulator/Makefile line 6
Quoted 12 lines
drivers/regulator/Makefile new file +6
-0@@ -0,0 +1,9 @@ +# +# Makefile for regulator drivers. +# + +obj-$(CONFIG_REGULATOR) += reg-core.o +
Replace this
drivers/regulator/Makefile line 9
Quoted 3 lines
drivers/regulator/Makefile new file +3
-0+ifeq ($(CONFIG_REGULATOR_DEBUG),y) + EXTRA_CFLAGS += -DDEBUG +endif
with this:
Quoted 1 line
+ccflags-$(CONFIG_REGULATOR_DEBUG) += -DDEBUG
Sam