Fixed pcnet io_base

Dear Ben,

this patch is still on my "open" list. Can you please review and apply if it makes sense to you? Thanks.

------- Forwarded Message

 Date:    Wed, 10 Oct 2007 23:02:09 +0300
 From:    Vlad Lungu <[email protected]>
 To:      u-boot-users at lists.sourceforge.net, wd at denx.de

Subject: [PATCH] Fixed pcnet io_base

Bus and phys address are not always the same

Signed-off-by Vlad Lungu <[email protected]>

---

  drivers/pcnet.c |    1 +
  1 files changed, 1 insertions(+), 0 deletions(-)

diff --git a/drivers/pcnet.c b/drivers/pcnet.c
index 2af0e8f..22edb48 100644
--- a/drivers/pcnet.c
+++ b/drivers/pcnet.c
@@ -196,6 +196,7 @@ int pcnet_initialize(bd_t *bis)
* Setup the PCI device.
*/
pci_read_config_dword(devbusfn, PCI_BASE_ADDRESS_0, (unsigned int *)&de
v->iobase);

 +       dev->iobase=pci_io_to_phys(devbusfn,dev->iobase);
        dev->iobase &= ~0xf;

        PCNET_DEBUG1("%s: devbusfn=0x%x iobase=0x%x: ",

--
1.5.2.2

------- End of Forwarded Message

Best regards,

Wolfgang Denk

--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Where a calculator on the ENIAC is equipped with 18,000 vacuum tubes and weighs 30 tons, computers in the future may have only 1,000 vacuum tubes and weigh only 1/2 tons. - Popular Mechanics, March 1949

Quoted 3 lines

this patch is still on my "open" list. Can you please review and apply if it makes sense to you? Thanks.

This looks OK to me. Assuming that pci_io_to_phys() is defined on all relevant architectures, I have no objections. Unfortunately I can't run MAKEALL right now, so if it's not too much of a bother please pull directly. We can always pull it out if there's a problem, I guess.

Bus and phys address are not always the same

Signed-off-by Vlad Lungu <[email protected]>

---
 drivers/pcnet.c |    1 +
 1 files changed, 1 insertions(+), 0 deletions(-)