Skip to contentSkip to conversation

Remove gap fill in srec object v2

PATCH New Ricardo Ribalda Delgado 2 participants 2 messages Sep 7, 2008 – Sep 9, 2008 Kbuild

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Remove gap fill in srec object v2

SREC files do not need gap fill: The load address is specified in the file. On the other hand, it can't be avoided in a .bin object. It has no information about memory location.

diff in v2:
-Change comment (wd)

---
 Makefile |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)
Makefile +1 -1
index 3869e79..c8c02dd 100644
@@ -295,7 +295,7 @@ $(obj)u-boot.hex:	$(obj)u-boot
 		$(OBJCOPY) ${OBJCFLAGS} -O ihex $< $@
 
 $(obj)u-boot.srec:	$(obj)u-boot
-		$(OBJCOPY) ${OBJCFLAGS} -O srec $< $@
+		$(OBJCOPY) -O srec $< $@
 
 $(obj)u-boot.bin:	$(obj)u-boot
 		$(OBJCOPY) ${OBJCFLAGS} -O binary $< $@
Signature · 1 line
1.5.6.5
#1 lore raw

PATCH 1/1 Remove gap fill in srec object v2

Dear Ricardo Ribalda Delgado,

Quoted 11 lines · In message <[email protected]> you wrote:

SREC files do not need gap fill: The load address is specified in the file. On the other hand, it can't be avoided in a .bin object. It has no information about memory location.

diff in v2:
-Change comment (wd)

---
 Makefile |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

Applied, thanks.

Note: the comment ("diff in v2: ...") should have been put *below* the '---' line.

Best regards,

Wolfgang Denk

Signature · 7 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"Logic and practical information do not seem to apply here."
"You admit that?"
"To deny the facts would be illogical, Doctor"
	-- Spock and McCoy, "A Piece of the Action", stardate unknown