Skip to contentSkip to conversation

How to start duplicate VG with new name and UUID?

linux-lvm Richard Michael 2 participants 3 messages Sep 17, 2008 – Sep 18, 2008

lore
Share & tools
lore
#0 lore raw

Hello list,

I'm using FC7 2.6.23.12-52.fc7 and LVM2 lvm2-2.02.24-1.fc7.

I have a RAID1 mdadm software array containing a VG. Half the array has been removed from the system and now returned and I want data from the old half, before it is resync'd back into the array.

I can start the old half as a new degraded mdadm array easily enough:
mdadm --assemble /dev/md3 --run --update=uuid /dev/sdc2

Of course, lvm complains about a duplicate volume group. So I want to rename and re-UUID the PV and VG. I've tried

pvchange --uuid /dev/md3

But lvm refuses because the volume group name is "vg0" in the /dev/md3 metadata and vg0 is an active volume group on /dev/md1, the other half of the RAID1. (It seems lvm's check is slightly naive and it is just looking at the name?)

How can change the metadata on /dev/md3 such that it can be activated without interfering with the currently active VG of the same name and uuid on /dev/md2?

I'm sure I've misunderstood something somewhere!

Aside, it's a bit alarming when the vg/pv related tools report "Found duplicate PV <uuid>: using /dev/md3 not /dev/md1". "Using" for what? Will the system change to using the newly connected duplicate PV? I definitely don't want it to do that!

Thanks,
Richard

#1 lore raw
Quoted 7 lines · Richard Michael

Hello list,

I'm using FC7 2.6.23.12-52.fc7 and LVM2 lvm2-2.02.24-1.fc7.

I have a RAID1 mdadm software array containing a VG. Half the array has been removed from the system and now returned and I want data from the old half, before it is resync'd back into the array.

See:

http://www.redhat.com/archives/linux-lvm/2007-November/msg00039.html

And the reply from Alasdair which improves a couple of the steps.

Regards,
Bryn.

#2 lore raw
Quoted 9 lines · Bryn M. Reeves
Quoted 7 lines · Richard Michael

Hello list,

I'm using FC7 2.6.23.12-52.fc7 and LVM2 lvm2-2.02.24-1.fc7.

I have a RAID1 mdadm software array containing a VG. Half the array has been removed from the system and now returned and I want data from the old half, before it is resync'd back into the array.

Quoted 5 lines

See:

http://www.redhat.com/archives/linux-lvm/2007-November/msg00039.html

And the reply from Alasdair which improves a couple of the steps.

Thanks Bryn. I actually did quite a bit of searching before posting, and found your message you reference, but it wasn't applicable as your first step was to deactivate the VG (and I can't deactive the existing VG with mounted LVs). But, I should have looked at Alasdair's reply, which solves that problem.

Sorry for the noise, and thanks for pointing me to his reply, I'll give it a go.

Regards,
Richard