Skip to contentSkip to conversation

Strange behavior since commit 5fef0e5c

DISCUSSION Larry Finger 3 participants 4 messages Nov 14, 2008 – Nov 17, 2008

lore
Share & tools
lore
#0 lore raw

In testing kernel version 2.6.28-rc4 on my server that was running kernel 2.6.27, an external IDE disk system connected via a PCCard interface failed to start because module ide_disk would not load. The console output is as follows:

finger@sonylap:~> sudo modprobe -v ide-disk
WARNING: module 'ide_gd_mod' is unsupported
FATAL: Module ide_disk not found.

I did not bisect this problem, but I believe that the following commit introduced this change:

commit 5fef0e5c0283949f95a7891c9424a9f84448116b

Author: Bartlomiej Zolnierkiewicz <[email protected]>
Date:   Fri Oct 17 18:09:12 2008 +0200

My work-around has been to change 'modprobe ide-disk' to 'modprobe ide-gd_mod' in my startup. Please note that one of the underscores is changed to a hyphen.

Thanks,

Larry

#1 lore raw
Quoted 7 lines · Larry Finger

In testing kernel version 2.6.28-rc4 on my server that was running kernel 2.6.27, an external IDE disk system connected via a PCCard interface failed to start because module ide_disk would not load. The console output is as follows:

finger@sonylap:~> sudo modprobe -v ide-disk
WARNING: module 'ide_gd_mod' is unsupported
FATAL: Module ide_disk not found.

Please verify that your system uses a recent module-init-tools version and then repeat 'make modules' + 'make modules_install' (it could be that something went wrong previously during installing modules) as it works just fine for me with 2.6.28-rc3 and module-init-tools 3.4.

Thanks,
Bart

#2 lore raw
Quoted 5 lines · Bartlomiej Zolnierkiewicz
Quoted 4 lines · Larry Finger

In testing kernel version 2.6.28-rc4 on my server that was running kernel 2.6.27, an external IDE disk system connected via a PCCard interface failed to start because module ide_disk would not load. The console output is as follows:

Quoted 8 lines
Quoted 3 lines

finger@sonylap:~> sudo modprobe -v ide-disk
WARNING: module 'ide_gd_mod' is unsupported
FATAL: Module ide_disk not found.

Please verify that your system uses a recent module-init-tools version and then repeat 'make modules' + 'make modules_install' (it could be that something went wrong previously during installing modules) as it works just fine for me with 2.6.28-rc3 and module-init-tools 3.4.

That was the problem. I had 3.3 pre11, which was installed by openSUSE 10.3. Updating to version 3.4 fixed the problem. Thanks.

Should the requirement in Documentation/Changes be modified, or is that info no longer used?

Larry

#3 lore raw
Quoted 15 lines · On Fri, 14 Nov 2008 15:26:17 -0600 Larry Finger wrote:
Quoted 5 lines · Bartlomiej Zolnierkiewicz
Quoted 4 lines · Larry Finger

In testing kernel version 2.6.28-rc4 on my server that was running kernel 2.6.27, an external IDE disk system connected via a PCCard interface failed to start because module ide_disk would not load. The console output is as follows:

Quoted 8 lines
Quoted 3 lines

finger@sonylap:~> sudo modprobe -v ide-disk
WARNING: module 'ide_gd_mod' is unsupported
FATAL: Module ide_disk not found.

Please verify that your system uses a recent module-init-tools version and then repeat 'make modules' + 'make modules_install' (it could be that something went wrong previously during installing modules) as it works just fine for me with 2.6.28-rc3 and module-init-tools 3.4.

Quoted 5 lines

That was the problem. I had 3.3 pre11, which was installed by openSUSE 10.3. Updating to version 3.4 fixed the problem. Thanks.

Should the requirement in Documentation/Changes be modified, or is that info no longer used?

IMO it should be updated (or deleted if it's really useless).

---
~Randy