Skip to contentSkip to conversation

82xx serial, smc: add configurable SMC Rx buffer len

U-Boot Applied Heiko Schocher 2 participants 2 messages Jan 30, 2009 – Feb 9, 2009

lore
Share & tools
lore
#0 lore raw

This patch adds the configuration option CONFIG_SYS_SMC_RXBUFLEN. With this option it is possible to allow the receive buffer for the SMC on 82xx to be greater then 1. In case CONFIG_SYS_SMC_RXBUFLEN == 1 this driver works as the old version.

When defining CONFIG_SYS_SMC_RXBUFLEN also CONFIG_SYS_MAXIDLE must be defined to setup the maximum idle timeout for the SMC.

---
 README                   |    8 ++++
 cpu/mpc8260/serial_smc.c |   97 ++++++++++++++++++++++++++++-----------------
 2 files changed, 68 insertions(+), 37 deletions(-)
README +8 -0
index 86c1304..fbdccb0 100644
@@ -484,6 +484,14 @@ The following options need to be configured:
 		CONFIG_SYS_BAUDRATE_TABLE, see below.
 		CONFIG_SYS_BRGCLK_PRESCALE, baudrate prescale
 
+- Console Rx buffer length
+		With CONFIG_SYS_SMC_RXBUFLEN it is possible to define
+		the maximum receive buffer length for the SMC.
+		This option is actual only for 82xx possible.
+		If using CONFIG_SYS_SMC_RXBUFLEN also CONFIG_SYS_MAXIDLE
+		must be defined, to setup the maximum idle timeout for
+		the SMC.
+
 - Interrupt driven serial port input:
 		CONFIG_SERIAL_SOFTWARE_FIFO
 
cpu/mpc8260/serial_smc.c +60 -37

171 lines not on this page · raw message

Signature · 5 lines
1.6.0.6

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
#1 lore raw

Dear Heiko Schocher,

Quoted 10 lines · In message <[email protected]> you wrote:

This patch adds the configuration option CONFIG_SYS_SMC_RXBUFLEN. With this option it is possible to allow the receive buffer for the SMC on 82xx to be greater then 1. In case CONFIG_SYS_SMC_RXBUFLEN == 1 this driver works as the old version.

When defining CONFIG_SYS_SMC_RXBUFLEN also CONFIG_SYS_MAXIDLE must be defined to setup the maximum idle timeout for the SMC.

Quoted 5 lines
---
 README                   |    8 ++++
 cpu/mpc8260/serial_smc.c |   97 ++++++++++++++++++++++++++++-----------------
 2 files changed, 68 insertions(+), 37 deletions(-)

Applied, thanks.

Best regards,

Wolfgang Denk

Signature · 7 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
If a packet hits a pocket on a socket on a port,
And the bus is interrupted as a very last resort,
And the address of the memory makes your floppy disk abort,
Then the socket packet pocket has an error to report! - Ken Burchill?