clocksource: sh_cmt 16-bit fixes
Subsystems (2)
PATCH 1/1 clocksource: sh_cmt 16-bit fixes
From: Magnus Damm <[email protected]>
This patch contains various fixes for 16-bit cmt hardware. With this applied periodic clockevents work fine on sh7203.
Signed-off-by Magnus Damm <[email protected]>
---
drivers/clocksource/sh_cmt.c | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-)
drivers/clocksource/sh_cmt.c +7 -5
@@ -153,16 +153,18 @@ static int sh_cmt_enable(struct sh_cmt_ppr_err ("sh_cmt: cannot enable clock \"%s\"\n" , cfg->clk);return ret; } - *rate =clk_get_rate (p->clk) /8 ;/* make sure channel is disabled */ sh_cmt_start_stop_ch (p,0 );/* configure channel, periodic mode and maximum timeout */ -if (p->width =16 ) -sh_cmt_write (p,CMCSR ,0 ); -else +if (p->width =16 ) { + *rate =clk_get_rate (p->clk) /512 ; +sh_cmt_write (p,CMCSR ,0x43 ); + }else { + *rate =clk_get_rate (p->clk) /8 ;sh_cmt_write (p,CMCSR ,0x01a4 ); + }sh_cmt_write (p,CMCOR ,0xffffffff );sh_cmt_write (p,CMCNT ,0 );
@@ -545,7 +547,7 @@ static int sh_cmt_setup(struct sh_cmt_prif (resource_size (res) =6 ) { p->width =16 ; p->overflow_bit =0x80 ; - p->clear_bits = ~0xc0 ; + p->clear_bits = ~0x80 ; }else { p->width =32 ; p->overflow_bit =0x8000 ;