Skip to contentSkip to conversation

clocksource: sh_cmt 16-bit fixes

PATCH New Magnus Damm 1 participant 1 message Apr 29, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 clocksource: sh_cmt 16-bit fixes

From: Magnus Damm <[email protected]>

This patch contains various fixes for 16-bit cmt hardware. With this applied periodic clockevents work fine on sh7203.

---

 drivers/clocksource/sh_cmt.c |   12 +++++++-----
 1 file changed, 7 insertions(+), 5 deletions(-)
drivers/clocksource/sh_cmt.c +7 -5
@@ -153,16 +153,18 @@ static int sh_cmt_enable(struct sh_cmt_p
 		pr_err("sh_cmt: cannot enable clock \"%s\"\n", cfg->clk);
 		return ret;
 	}
-	*rate = clk_get_rate(p->clk) / 8;
 
 	/* make sure channel is disabled */
 	sh_cmt_start_stop_ch(p, 0);
 
 	/* configure channel, periodic mode and maximum timeout */
-	if (p->width = 16)
-		sh_cmt_write(p, CMCSR, 0);
-	else
+	if (p->width = 16) {
+		*rate = clk_get_rate(p->clk) / 512;
+		sh_cmt_write(p, CMCSR, 0x43);
+	} else {
+		*rate = clk_get_rate(p->clk) / 8;
 		sh_cmt_write(p, CMCSR, 0x01a4);
+	}
 
 	sh_cmt_write(p, CMCOR, 0xffffffff);
 	sh_cmt_write(p, CMCNT, 0);
@@ -545,7 +547,7 @@ static int sh_cmt_setup(struct sh_cmt_pr
 	if (resource_size(res) = 6) {
 		p->width = 16;
 		p->overflow_bit = 0x80;
-		p->clear_bits = ~0xc0;
+		p->clear_bits = ~0x80;
 	} else {
 		p->width = 32;
 		p->overflow_bit = 0x8000;