Skip to contentSkip to conversation

sh: add mode4 pin support to sh7785 clock code

PATCH New Magnus Damm 1 participant 1 message May 7, 2009 SuperH

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 sh: add mode4 pin support to sh7785 clock code

From: Magnus Damm <[email protected]>

Use early_param() to select mode4 configuration for the sh7785 clock code. Without this patch there is no board configuration code that selects PLL multiplier (36x/72x) for sh7785.

The board code must make sure that mode4 is setup according to the hardware configuration.

---

 arch/sh/kernel/cpu/sh4a/clock-sh7785.c |   18 +++++++++++++++++-
 1 file changed, 17 insertions(+), 1 deletion(-)
arch/sh/kernel/cpu/sh4a/clock-sh7785.c +17 -1
@@ -15,6 +15,22 @@
 #include <asm/freq.h>
 #include <asm/io.h>
 
+static int mode4_pin;
+
+static int __init setup_mode4_pin(char *buf)
+{
+	if (buf) {
+		if (strstr(buf, "high"))
+			mode4_pin = 1;
+
+		if (strstr(buf, "low"))
+			mode4_pin = 0;
+	}
+
+	return 0;
+}
+early_param("mode4_pin", setup_mode4_pin);
+
 static int ifc_divisors[] = { 1, 2, 4, 6 };
 static int ufc_divisors[] = { 1, 1, 4, 6 };
 static int sfc_divisors[] = { 1, 1, 4, 6 };
@@ -26,7 +42,7 @@ static int pfc_divisors[] = { 1, 1, 1, 1
 
 static void master_clk_init(struct clk *clk)
 {
-	clk->rate *= pfc_divisors[ctrl_inl(FRQMR1) & 0x000f];
+	clk->rate *= mode4_pin ? 36 : 72;
 }
 
 static struct clk_ops sh7785_master_clk_ops = {