sh: add mode4 pin support to sh7785 clock code
PATCH 1/1 sh: add mode4 pin support to sh7785 clock code
From: Magnus Damm <[email protected]>
Use early_param() to select mode4 configuration for the sh7785 clock code. Without this patch there is no board configuration code that selects PLL multiplier (36x/72x) for sh7785.
The board code must make sure that mode4 is setup according to the hardware configuration.
Signed-off-by Magnus Damm <[email protected]>
---
arch/sh/kernel/cpu/sh4a/clock-sh7785.c | 18 +++++++++++++++++- 1 file changed, 17 insertions(+), 1 deletion(-)
arch/sh/kernel/cpu/sh4a/clock-sh7785.c +17 -1
@@ -15,6 +15,22 @@#include <asm/freq.h> #include <asm/io.h> +static int mode4_pin; + +static int __init setup_mode4_pin (char *buf) +{ +if (buf) { +if (strstr (buf,"high" )) + mode4_pin =1 ; + +if (strstr (buf,"low" )) + mode4_pin =0 ; + } + +return 0 ; +} +early_param ("mode4_pin" , setup_mode4_pin); +static int ifc_divisors[] = {1 ,2 ,4 ,6 };static int ufc_divisors[] = {1 ,1 ,4 ,6 };static int sfc_divisors[] = {1 ,1 ,4 ,6 };
@@ -26,7 +42,7 @@ static int pfc_divisors[] = { 1, 1, 1, 1static void master_clk_init (struct clk *clk) { - clk->rate *= pfc_divisors[ctrl_inl (FRQMR1 ) &0x000f ]; + clk->rate *= mode4_pin ?36 :72 ; }static struct clk_ops sh7785_master_clk_ops = {