Skip to contentSkip to conversation

mmc_spi: don't use EINVAL for possible transmission errors

PATCH New Wolfgang Mües 1 participant 1 message May 26, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 mmc_spi: don't use EINVAL for possible transmission errors

From: Wolfgang Muees <[email protected]>

o This patch changes the reported error code for the responses to a command from EINVAL to EFAULT/ENOSYS, as EINVAL is reserved for non-recoverable host errors, and the responses from the SD/MMC card may be because of recoverable transmission errors in the command or in the response. Response codes in SPI mode are NOT protected by a checksum, so don't trust them.

This is a revised, minimal-invasive patch version. As Pierre Ossman pointed out, EINVAL should only be used for non-recoverable errors (and is used so in the whole rest of the mmc framework).

I have checked every instance of EINVAL in the mmc framework - no changes were needed here.

This patch is neccessary for doing a sensible retry managment in the mmmc block layer (patch will follow).

---

drivers/mmc/host/mmc_spi.c +6 -5
diff -uprN 2_6_29_rc7_patch_wearout_speedup/drivers/mmc/host/mmc_spi.c 2_6_29_rc7_patch_EILSEQ/drivers/mmc/host/mmc_spi.c
@@ -335,15 +335,16 @@ checkstatus:
 
 	/* Status byte: the entire seven-bit R1 response.  */
 	if (cmd->resp[0] != 0) {
-		if ((R1_SPI_PARAMETER | R1_SPI_ADDRESS
-				      | R1_SPI_ILLEGAL_COMMAND)
+		if ((R1_SPI_PARAMETER | R1_SPI_ADDRESS)
 				& cmd->resp[0])
-			value = -EINVAL;
+			value = -EFAULT; /* Bad address */
+		else if (R1_SPI_ILLEGAL_COMMAND & cmd->resp[0])
+			value = -ENOSYS; /* Function not implemented */
 		else if (R1_SPI_COM_CRC & cmd->resp[0])
-			value = -EILSEQ;
+			value = -EILSEQ; /* Illegal byte sequence */
 		else if ((R1_SPI_ERASE_SEQ | R1_SPI_ERASE_RESET)
 				& cmd->resp[0])
-			value = -EIO;
+			value = -EIO;    /* I/O error */
 		/* else R1_SPI_IDLE, "it's resetting" */
 	}
 

---
regards

i. A. Wolfgang Mües

Signature · 13 lines
Auerswald GmbH & Co. KG
Hardware Development
Telefon: +49 (0)5306 9219 0
Telefax: +49 (0)5306 9219 94 
E-Mail: [email protected]
Web: http://www.auerswald.de
 
--------------------------------------------------------------
Auerswald GmbH & Co. KG, Vor den Grashöfen 1, 38162 Cremlingen
Registriert beim AG Braunschweig HRA 13289
p.h.G Auerswald Geschäftsführungsges. mbH
Registriert beim AG Braunschweig HRB 7463
Geschäftsführer: Dipl-Ing. Gerhard Auerswald