floating point operation in powerpc
hi all
i am porting u-boot on powerpc 440.
i am also running a simple hello world application on it and I want to use floating point unit.
i have declared a floating point variable like this :
/float ftemp;
/ i am trying to print the floating point value like this:
/printf("ftemp=%f\n",ftemp);
/ i have included "float.h"
but still it doesnt print me the exact floating point value. my output is like this:
/ftemp=%f
/ i have not edited MSR register. should i set the bit 18 for using the FPU in PPC?
where am I going wrong in using floating point? is there any switch or library that i should include while compiling the hello_world.c?
this might be seem very silly, but please help in sorting out this issue.
Signature · 2 lines
Regards, Prathika R
Dear prathika,
Quoted 4 lines · In message <[email protected]> you wrote:
i am porting u-boot on powerpc 440.
i am also running a simple hello world application on it and I want to use floating point unit.
Boot an operating system, then.
U-Boot is just a boot loader, and we do not support any FP operations in U-Boot.
Quoted 2 lines
where am I going wrong in using floating point? is there any switch or library that i should include while compiling the
hello_world.c?
Boot Linux, and run your application in Linux.
Best regards,
Wolfgang Denk
Signature · 4 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de What's the sound a name makes when it's dropped?