Skip to contentSkip to conversation

floating point operation in powerpc

U-Boot prathika 2 participants 2 messages Aug 6, 2009

lore
Share & tools
lore

prathika

author
#0 lore raw

hi all
i am porting u-boot on powerpc 440.
i am also running a simple hello world application on it and I want to use floating point unit.

i have declared a floating point variable like this :
/float ftemp;

/ i am trying to print the floating point value like this:
/printf("ftemp=%f\n",ftemp);

/ i have included "float.h"

but still it doesnt print me the exact floating point value. my output is like this:
/ftemp=%f

/ i have not edited MSR register. should i set the bit 18 for using the FPU in PPC?
where am I going wrong in using floating point? is there any switch or library that i should include while compiling the hello_world.c?

this might be seem very silly, but please help in sorting out this issue.

Signature · 2 lines
Regards,
Prathika R
#1 lore raw

Dear prathika,

Quoted 4 lines · In message <[email protected]> you wrote:

i am porting u-boot on powerpc 440.
i am also running a simple hello world application on it and I want to use floating point unit.

Boot an operating system, then.

U-Boot is just a boot loader, and we do not support any FP operations in U-Boot.

Quoted 2 lines

where am I going wrong in using floating point? is there any switch or library that i should include while compiling the hello_world.c?

Boot Linux, and run your application in Linux.

Best regards,

Wolfgang Denk

Signature · 4 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
What's the sound a name makes when it's dropped?