Skip to contentSkip to conversation

acpi: thermal: display forced passive trip points in proc

PATCH In review [email protected] 1 participant 1 message Nov 17, 2009

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 7/12 acpi: thermal: display forced passive trip points in proc

From: Frans Pop <[email protected]>

Users can force a passive trip point for a thermal zone that does not have _PSV defined in ACPI by setting the passive attribute in sysfs. It's useful to display such trip points in /proc/acpi/thermal_zone.

.../TZ1/cooling_mode:<setting not supported>
.../TZ1/polling_frequency:polling frequency: 10 seconds
.../TZ1/state:state: ok

.../TZ1/temperature:temperature:             53 C
.../TZ1/trip_points:critical (S5):           110 C
.../TZ1/trip_points:passive (forced):        95 C

And if not set (passive is 0):
.../TZ1/trip_points:passive (forced):<not set>

---

 drivers/acpi/thermal.c |    7 +++++++
 1 file changed, 7 insertions(+)
drivers/acpi/thermal.c renamed from drivers/acpi/thermal.c~acpi-thermal-display-forced-passive-trip-points-in-proc +7 -0
diff -puN drivers/acpi/thermal.c~acpi-thermal-display-forced-passive-trip-points-in-proc drivers/acpi/thermal.c
@@ -1052,6 +1052,13 @@ static int acpi_thermal_trip_seq_show(st
 				   acpi_device_bid(device));
 		}
 		seq_puts(seq, "\n");
+	} else {
+		seq_printf(seq, "passive (forced):");
+		if (tz->thermal_zone->forced_passive)
+			seq_printf(seq, "        %i C\n",
+				   tz->thermal_zone->forced_passive / 1000);
+		else
+			seq_printf(seq, "<not set>\n");
 	}
 
 	for (i = 0; i < ACPI_THERMAL_MAX_ACTIVE; i++) {

_