acpi: thermal: display forced passive trip points in proc
Subsystems (2)
PATCH 7/12 acpi: thermal: display forced passive trip points in proc
From: Frans Pop <[email protected]>
Users can force a passive trip point for a thermal zone that does not have _PSV defined in ACPI by setting the passive attribute in sysfs. It's useful to display such trip points in /proc/acpi/thermal_zone.
.../TZ1/cooling_mode:<setting not supported>
.../TZ1/polling_frequency:polling frequency: 10 seconds
.../TZ1/state:state: ok
.../TZ1/temperature:temperature: 53 C .../TZ1/trip_points:critical (S5): 110 C .../TZ1/trip_points:passive (forced): 95 C
And if not set (passive is 0):
.../TZ1/trip_points:passive (forced):<not set>
Signed-off-by Frans Pop <[email protected]>
Acked-by Zhang Rui <[email protected]>
Cc Matthew Garrett <[email protected]>
Cc Len Brown <[email protected]>
Signed-off-by Andrew Morton <[email protected]>
---
drivers/acpi/thermal.c | 7 +++++++ 1 file changed, 7 insertions(+)
drivers/acpi/thermal.c renamed from drivers/acpi/thermal.c~acpi-thermal-display-forced-passive-trip-points-in-proc +7 -0
@@ -1052,6 +1052,13 @@ static int acpi_thermal_trip_seq_show(st acpi_device_bid(device)); }seq_puts (seq,"\n" ); + }else { +seq_printf (seq,"passive (forced):" ); +if (tz->thermal_zone->forced_passive) +seq_printf (seq," %i C\n" , + tz->thermal_zone->forced_passive /1000 ); +else +seq_printf (seq,"<not set>\n" ); }for (i =0 ; i <ACPI_THERMAL_MAX_ACTIVE ; i++) {
_