Skip to contentSkip to conversation

bttv: add i2c addr for old WinTV card to IR probe list

PATCH New Jarod Wilson 1 participant 1 message Dec 2, 2009 Media (V4L/DVB)

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 bttv: add i2c addr for old WinTV card to IR probe list

There are old bttv-driven Hauppauge WinTV series cards that have their IR part at i2c addr 0x71, which doesn't get considered in the new 2.6.31 i2c code.

Quoted 1 line

From a 2.6.29 kernel:

lirc_i2c: chip 0x10005 found @ 0x71 (Hauppauge PVR150)

Minor cosmetic glitch, the card in question isn't actually a PVR-150, its:

03:06.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 11)
Subsystem: Hauppauge computer works Inc. WinTV Series
Flags: bus master, medium devsel, latency 32, IRQ 19
Memory at f4ffe000 (32-bit, prefetchable) [size=4K]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
Kernel driver in use: bttv
Kernel modules: bttv

Device ID: 0x109e:0x036e, Sub-Device ID: 0x0070:0x13eb

This simply adds 0x71 to the list of addresses i2c_new_probed_device should consider, which gets IR working on this card again.

---

linux/drivers/media/video/bt8xx/bttv-i2c.c +1 -1
diff -r e0cd9a337600 linux/drivers/media/video/bt8xx/bttv-i2c.c
@@ -423,7 +423,7 @@
 		   That's why we probe 0x1a (~0x34) first. CB
 		*/
 		const unsigned short addr_list[] = {
-			0x1a, 0x18, 0x4b, 0x64, 0x30,
+			0x1a, 0x18, 0x4b, 0x64, 0x30, 0x71,
 			I2C_CLIENT_END
 		};