hwmon: Remove in[0-*]_fault from
Subsystems (2)
PATCH 1/1 hwmon: Remove in[0-*]_fault from
Fault files are for hardware failures that can be reported. So far we've seen chips reporting such failures for temperature sensors and fans, but not for voltages. Remove in[0-*]_fault for now. It can be added back later if really needed, but I doubt it.
Signed-off-by Jean Delvare <[email protected]>
Cc Guenter Roeck <[email protected]>
--- Documentation/hwmon/sysfs-interface | 1 - 1 file changed, 1 deletion(-)
Documentation/hwmon/sysfs-interface +0 -1
@@ -516,7 +516,6 @@ to notify open diodes, unconnected fans supports it. When this boolean has value 1, the measurement for that channel should not be trusted. -in[0-*]_fault fan[1-*]_fault temp[1-*]_fault Input fault condition
Signature · 6 lines
Jean Delvare _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
Quoted 7 lines · Jean Delvare
Fault files are for hardware failures that can be reported. So far we've seen chips reporting such failures for temperature sensors and fans, but not for voltages. Remove in[0-*]_fault for now. It can be added back later if really needed, but I doubt it.
Signed-off-by Jean Delvare <[email protected]>Cc Guenter Roeck <[email protected]>
Acked-by Guenter Roeck <[email protected]>
Quoted 18 lines
--- Documentation/hwmon/sysfs-interface | 1 - 1 file changed, 1 deletion(-)Documentation/hwmon/sysfs-interface +0
-1@@ -516,7 +516,6 @@ to notify open diodes, unconnected fans supports it. When this boolean has value 1, the measurement for that channel should not be trusted. -in[0-*]_fault fan[1-*]_fault temp[1-*]_fault Input fault conditionSignature · 2 lines
-- Jean Delvare
_______________________________________________
lm-sensors mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors