Debugger(BDI3000) Error !
Dear All
I use BDI3000 debugger to debug my custom board using PPC440EP , using Yosemite config file as base.
After board power on following messages are shown:
- TARGET: waiting for target Vcc
- TARGET: processing power-up delay
- TARGET: processing user reset request
- TARGET: resetting target passed
- TARGET: processing target startup ....
- TARGET: core #0 PVR is 0x422218D4
- TARGET: processing target startup passed
440EP>go
440EP>
According to BDI3000 manual it's expected to see this message after go command:
- TARGET: core #0 has entered debug mode
But i don't have it.
After go command i see u-boot messages in serial communication page but I think there is an error during startup in debugger and because of that i don't have this message.
Is there any idea about this error?
Thank you all!
Tim Rachman
Dear Tim Rachman,
Quoted 5 lines · In message <[email protected]> you wrote:
I use BDI3000 debugger to debug my custom board using PPC440EP , using Yosemite config file as base.
After board power on following messages are shown:
Quoted 9 lines
- TARGET: waiting for target Vcc
- TARGET: processing power-up delay
- TARGET: processing user reset request
- TARGET: resetting target passed
- TARGET: processing target startup ....
- TARGET: core #0 PVR is0x422218D4
- TARGET: processing target startup passed
440EP>go
440EP>
This looks good...
Quoted 6 lines
According to BDI3000 manual it's expected to see this message after go command:
- TARGET: core #0 has entered debug mode
But i don't have it.
This depends on how you reset your board. Pleas enote that there are several variabts of the "reset" command. "reset run" works quite differently from "reset halt". The BI stores the last use, so when you just type "reset" it repeats the last mode.
Quoted 1 line
Is there any idea about this error?
I don't see any error.
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
The most difficult thing in the world is to know how to do a thing
and to watch someone else doing it wrong, without commenting.
-- T.H. White