Skip to contentSkip to conversation

hda: again low volume problem :-(

DISCUSSION Halim Sahin 1 participant 1 message Jan 9, 2011

lore
Share & tools
lore
#0 lore raw

hi Folks,

i see the low volume problem is not only related to my hardware but reported a few times in alsa-user mailinglist.
Please! have a look in to that problem.
Using 100% of the volume sliders in alsamixer is not enough to get usable sound for the amp.
here my last mail ng the same problemd

Hi,

Quoted 3 lines · Takashi Iwai

First off, try with the latest version of alsa-driver.
Get the snapshot version from
ftp://ftp.kernel.org/pub/linux/kernel/people/tiwai/snapshot/alsa-driver-snapshot.tar.gz

Done. Compilation and load of the modules are ok but the volume stays low on the rear panel of the computer.

Quoted 6 lines

If this doesn't help, try to set EAPD on NID 0x14 and/or 0x15, set it to 0x02. Get hda-verb program (available on OBS home:tiwai repo), then run like

	hda-verb /dev/snd/hwC0D0 0x14 SET_EAPD 0x02
	hda-verb /dev/snd/hwC0D0 0x15 SET_EAPD 0x02

also no success with hda-verb.
Do you have more ideas what I can test?

Maybe this aditional info helps you :-).
I noticed a difference in volume between headphone (front connector) and the line out (rear panel connector).
The volume is higher when using the headphone connector but should also be improoved a bit :-(.
this info is from alsamixer and the new driver:
Card: HDA NVidia
Chip: Nvidia ID 7
This info is from the orginal driver of kernel 2.6.34:
Card: HDA NVidia
Chip: Nvidia MCP79/7A HDMI

Why does alsamixer show Chip: Nvidia ID 7 with new driver?

All help appreciated ;-)

BR.
halim