hda: again low volume problem :-(
hi Folks,
i see the low volume problem is not only related to my hardware but reported a few times in alsa-user mailinglist.
Please! have a look in to that problem.
Using 100% of the volume sliders in alsamixer is not enough to get usable sound for the amp.
here my last mail ng the same problemd
Hi,
Quoted 3 lines · Takashi Iwai
First off, try with the latest version of alsa-driver.
Get the snapshot version from
ftp://ftp.kernel.org/pub/linux/kernel/people/tiwai/snapshot/alsa-driver-snapshot.tar.gz
Done. Compilation and load of the modules are ok but the volume stays low on the rear panel of the computer.
Quoted 6 lines
If this doesn't help, try to set EAPD on NID
0x14and/or0x15, set it to0x02. Get hda-verb program (available on OBS home:tiwai repo), then run likehda-verb /dev/snd/hwC0D0 0x14 SET_EAPD 0x02 hda-verb /dev/snd/hwC0D0 0x15 SET_EAPD 0x02
also no success with hda-verb.
Do you have more ideas what I can test?
Maybe this aditional info helps you :-).
I noticed a difference in volume between headphone (front connector) and the line out (rear panel connector).
The volume is higher when using the headphone connector but should also be improoved a bit :-(.
this info is from alsamixer and the new driver:
Card: HDA NVidia
Chip: Nvidia ID 7
This info is from the orginal driver of kernel 2.6.34:
Card: HDA NVidia
Chip: Nvidia MCP79/7A HDMI
Why does alsamixer show Chip: Nvidia ID 7 with new driver?
All help appreciated ;-)
BR.
halim