Skip to contentSkip to conversation

ARM: Allow user selection HZ values

RFC New Russell King - ARM Linux 1 participant 1 message May 16, 2013 Arm (32-bit)

lore
Share & tools
lore
#0 lore raw

RFC 1/1 ARM: Allow user selection HZ values

Allow users to configure the Hz rate on implementations which do not have a fixed clock rate.

---
Whenever HZ_FIXED is not set through one of its "default" settings, the user is allowed to select a tick rate from 100, 200, 250, 300, 500Hz and 1kHz. This is slightly more choice than with the generic HZ selection in kernel/Kconfig.hz (which only does 100, 250, 300Hz and 1kHz). The reason for including 200Hz is that a greater number of other platforms want that via the fixed rate, and 500Hz just seemed to be a better middle value than 300Hz (which is of course stupidly close to 250.)

 arch/arm/Kconfig |   40 ++++++++++++++++++++++++++++++++++++++--
 1 files changed, 38 insertions(+), 2 deletions(-)
arch/arm/Kconfig +38 -2
index 67874b8..dcd16ff 100644
@@ -1646,14 +1646,50 @@ config ARCH_NR_GPIO
 
 source kernel/Kconfig.preempt
 
-config HZ
+config HZ_FIXED
 	int
 	default 200 if ARCH_EBSA110 || ARCH_S3C24XX || ARCH_S5P64X0 || \
 		ARCH_S5PV210 || ARCH_EXYNOS4
 	default OMAP_32K_TIMER_HZ if ARCH_OMAP && OMAP_32K_TIMER
 	default AT91_TIMER_HZ if ARCH_AT91
 	default SHMOBILE_TIMER_HZ if ARCH_SHMOBILE
-	default 100
+
+choice
+	depends on !HZ_FIXED
+	prompt "Timer frequency"
+
+config HZ_100
+	bool "100 Hz"
+
+config HZ_200
+	bool "200 Hz"
+
+config HZ_250
+	bool "250 Hz"
+
+config HZ_300
+	bool "300 Hz"
+
+config HZ_500
+	bool "500 Hz"
+
+config HZ_1000
+	bool "1000 Hz"
+
+endchoice
+
+config HZ
+	int
+	default HZ_FIXED if HZ_FIXED
+	default 100 if HZ_100
+	default 200 if HZ_200
+	default 250 if HZ_250
+	default 300 if HZ_300
+	default 500 if HZ_500
+	default 1000
+
+config SCHED_HRTICK
+	def_bool HIGH_RES_TIMERS
 
 config THUMB2_KERNEL
 	bool "Compile the kernel in Thumb-2 mode"
Signature · 1 line
1.7.4.4