Skip to contentSkip to conversation

ASM code for UART initialization

U-Boot André Schaller 2 participants 2 messages Jun 6, 2013

lore
Share & tools
lore
#0 lore raw

Hi,

could someone support me with developing ASM code for initializing UART interface on OMAP4460 to send some bytes over the wire at a very early stage of booting x-loader? The code needs to be executed in start.S.

Is it possible to use existing C code and use the generated assembly from gcc as the actual code or does it need major modifications to be executed in start.S?

Thanks in advance.

Regards,
Andr?

#1 lore raw

Dear Andr? Schaller,

Quoted 4 lines · In message <[email protected]> you wrote:

could someone support me with developing ASM code for initializing UART interface on OMAP4460 to send some bytes over the wire at a very early stage of booting x-loader? The code needs to be executed in start.S.

Why would you not just use C code?

Quoted 3 lines

Is it possible to use existing C code and use the generated assembly from gcc as the actual code or does it need major modifications to be executed in start.S?

It should be possible - but you should ask yourself what you then prevents from using C code instead?

Best regards,

Wolfgang Denk

Signature · 7 lines
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
They weren't that important. They were merely at the top. The  people
who  really  run organizations are usually found several levels down,
where it's still possible to get things done.
                                      - Terry Pratchett, _Small Gods_