ASM code for UART initialization
Hi,
could someone support me with developing ASM code for initializing UART interface on OMAP4460 to send some bytes over the wire at a very early stage of booting x-loader? The code needs to be executed in start.S.
Is it possible to use existing C code and use the generated assembly from gcc as the actual code or does it need major modifications to be executed in start.S?
Thanks in advance.
Regards,
Andr?
Dear Andr? Schaller,
Quoted 4 lines · In message <[email protected]> you wrote:
could someone support me with developing ASM code for initializing UART interface on OMAP4460 to send some bytes over the wire at a very early stage of booting x-loader? The code needs to be executed in
start.S.
Why would you not just use C code?
Quoted 3 lines
Is it possible to use existing C code and use the generated assembly from gcc as the actual code or does it need major modifications to be executed in
start.S?
It should be possible - but you should ask yourself what you then prevents from using C code instead?
Best regards,
Wolfgang Denk
Signature · 7 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
They weren't that important. They were merely at the top. The people
who really run organizations are usually found several levels down,
where it's still possible to get things done.
- Terry Pratchett, _Small Gods_