hwmon: (pwm-fan) Fix suspend/resume behavior
PATCH 1/1 hwmon: (pwm-fan) Fix suspend/resume behavior
The state of a PWM output is not clearly defined after resume. Some PWM drivers do not restore the duty cycle upon resume, thus it is necessary to manually restore the correct value.
Signed-off-by Kamil Debski <[email protected]>
--- drivers/hwmon/pwm-fan.c | 13 ++++++++++--- 1 file changed, 10 insertions(+), 3 deletions(-)
drivers/hwmon/pwm-fan.c +10 -3
@@ -161,10 +161,17 @@ static int pwm_fan_suspend(struct device *dev)static int pwm_fan_resume (struct device *dev) {struct pwm_fan_ctx *ctx =dev_get_drvdata (dev); +unsigned long duty; +int ret; -if (ctx->pwm_value) -return pwm_enable (ctx->pwm); -return 0 ; +if (ctx->pwm_value =0 ) +return 0 ; + + duty =DIV_ROUND_UP (ctx->pwm_value * (ctx->pwm->period -1 ),MAX_PWM ); + ret =pwm_config (ctx->pwm, duty, ctx->pwm->period); +if (ret) +return ret; +return pwm_enable (ctx->pwm); }#endif
Signature · 7 lines
1.7.9.5 _______________________________________________ lm-sensors mailing list [email protected] http://lists.lm-sensors.org/mailman/listinfo/lm-sensors
Quoted 5 lines · Kamil Debski
The state of a PWM output is not clearly defined after resume. Some PWM drivers do not restore the duty cycle upon resume, thus it is necessary to manually restore the correct value.
Signed-off-by Kamil Debski <[email protected]>
Applied.
Thanks,
Guenter
_______________________________________________
lm-sensors mailing list
[email protected]
http://lists.lm-sensors.org/mailman/listinfo/lm-sensors