Add support for DS28EA00 sequence to w1-therm
Subsystems (2)
PATCH 1/1 Add support for DS28EA00 sequence to w1-therm
This patch provides support for the DS28EA00 digital thermometer.
The DS28EA00 provides an additional two pins for implementing a sequence detection algorithm. This feature allows you to determine the physical location of the chip in the 1-wire bus without needing pre-existing knowledge of the bus ordering. Support is provided through the sysfs w1_seq file. The file will contain a single line with an integer value representing the device index in the bus starting at 0.
Documentation/ABI/stable/sysfs-driver-w1_ds28ea00 new file +6 -0
@@ -0,0 +1,6 @@ +What: /sys/bus/w1/devices/.../w1_seq +Date: Apr 2015 +Contact: Matt Campbell <[email protected]> +Description: Support for the DS28EA00 chain sequence function + see Documentation/w1/slaves/w1_therm for detailed information +Users: any user space application which wants to communicate with DS28EA00
Documentation/w1/slaves/w1_therm +10 -1
@@ -11,12 +11,14 @@ Author: Evgeniy Polyakov <[email protected]> Description ----------- -w1_therm provides basic temperature conversion for ds18*20 devices. +w1_therm provides basic temperature conversion for ds18*20 devices, and the +ds28ea00 device. supported family codes: W1_THERM_DS18S20 0x10 W1_THERM_DS1822 0x22 W1_THERM_DS18B20 0x28 W1_THERM_DS1825 0x3B +W1_THERM_DS28EA00 0x42 Support is provided through the sysfs w1_slave file. Each open and read sequence will initiate a temperature conversion then provide two
@@ -48,3 +50,10 @@ resistor). The DS18b20 temperature sensor specification lists a maximum current draw of 1.5mA and that a 5k pullup resistor is not sufficient. The strong pullup is designed to provide the additional current required. + +The DS28EA00 provides an additional two pins for implementing a sequence +detection algorithm. This feature allows you to determine the physical +location of the chip in the 1-wire bus without needing pre-existing +knowledge of the bus ordering. Support is provided through the sysfs +w1_seq file. The file will contain a single line with an integer value +representing the device index in the bus starting at 0.
drivers/w1/slaves/w1_therm.c +101 -1
133 lines not on this page · raw message
Hi
28.04.2015, 14:44, "Matt Campbell" <[email protected]>:
Quoted 1 line
This patch provides support for the DS28EA00 digital thermometer.
Patch looks good, Greg, please pull this patch into you tree