Skip to contentSkip to conversation

Add support for DS28EA00 sequence to w1-therm

PATCH In review Matt Campbell 2 participants 2 messages Apr 28, 2015 – May 2, 2015

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Add support for DS28EA00 sequence to w1-therm

This patch provides support for the DS28EA00 digital thermometer.

The DS28EA00 provides an additional two pins for implementing a sequence detection algorithm. This feature allows you to determine the physical location of the chip in the 1-wire bus without needing pre-existing knowledge of the bus ordering. Support is provided through the sysfs w1_seq file. The file will contain a single line with an integer value representing the device index in the bus starting at 0.

Documentation/ABI/stable/sysfs-driver-w1_ds28ea00 new file +6 -0
new file mode 100644
index 0000000..e928def
@@ -0,0 +1,6 @@
+What:		/sys/bus/w1/devices/.../w1_seq
+Date:		Apr 2015
+Contact:	Matt Campbell <[email protected]>
+Description:	Support for the DS28EA00 chain sequence function
+		see Documentation/w1/slaves/w1_therm for detailed information
+Users:		any user space application which wants to communicate with DS28EA00
Documentation/w1/slaves/w1_therm +10 -1
index cc62a95..13411fe 100644
@@ -11,12 +11,14 @@ Author: Evgeniy Polyakov <[email protected]>
 Description
 -----------
 
-w1_therm provides basic temperature conversion for ds18*20 devices.
+w1_therm provides basic temperature conversion for ds18*20 devices, and the
+ds28ea00 device.
 supported family codes:
 W1_THERM_DS18S20	0x10
 W1_THERM_DS1822		0x22
 W1_THERM_DS18B20	0x28
 W1_THERM_DS1825		0x3B
+W1_THERM_DS28EA00	0x42
 
 Support is provided through the sysfs w1_slave file.  Each open and
 read sequence will initiate a temperature conversion then provide two
@@ -48,3 +50,10 @@ resistor).  The DS18b20 temperature sensor specification lists a
 maximum current draw of 1.5mA and that a 5k pullup resistor is not
 sufficient.  The strong pullup is designed to provide the additional
 current required.
+
+The DS28EA00 provides an additional two pins for implementing a sequence
+detection algorithm.  This feature allows you to determine the physical
+location of the chip in the 1-wire bus without needing pre-existing
+knowledge of the bus ordering.  Support is provided through the sysfs
+w1_seq file.  The file will contain a single line with an integer value
+representing the device index in the bus starting at 0.
drivers/w1/slaves/w1_therm.c +101 -1

133 lines not on this page · raw message

#1 lore raw

Hi

28.04.2015, 14:44, "Matt Campbell" <[email protected]>:

Quoted 1 line

This patch provides support for the DS28EA00 digital thermometer.

Patch looks good, Greg, please pull this patch into you tree