Skip to contentSkip to conversation

drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.

PATCH New Eric Anholt 1 participant 1 message Sep 14, 2016

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.

On Pi0/1/2, we use an external GPIO line for hotplug detection, since the HDMI_HOTPLUG register isn't connected to anything. However, with the Pi3 the HPD GPIO line has moved off to a GPIO expander that will be tricky to get to (the firmware is constantly polling the expander using i2c0, so we'll need to coordinate with it).

As a stop-gap, if we don't have a GPIO line, use an EDID probe to detect connection. Fixes HDMI display on the pi3.

---
 drivers/gpu/drm/vc4/vc4_hdmi.c | 3 +++
 1 file changed, 3 insertions(+)
drivers/gpu/drm/vc4/vc4_hdmi.c +3 -0
index 68ad10634b29..9f85a579da74 100644
@@ -174,6 +174,9 @@ vc4_hdmi_connector_detect(struct drm_connector *connector, bool force)
 			return connector_status_disconnected;
 	}
 
+	if (drm_probe_ddc(vc4->hdmi->ddc))
+		return connector_status_connected;
+
 	if (HDMI_READ(VC4_HDMI_HOTPLUG) & VC4_HDMI_HOTPLUG_CONNECTED)
 		return connector_status_connected;
 	else
Signature · 6 lines
2.9.3

_______________________________________________
dri-devel mailing list
[email protected]
https://lists.freedesktop.org/mailman/listinfo/dri-devel