drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.
Subsystems (3)
PATCH 1/1 drm/vc4: Fall back to using an EDID probe in the absence of a GPIO.
On Pi0/1/2, we use an external GPIO line for hotplug detection, since the HDMI_HOTPLUG register isn't connected to anything. However, with the Pi3 the HPD GPIO line has moved off to a GPIO expander that will be tricky to get to (the firmware is constantly polling the expander using i2c0, so we'll need to coordinate with it).
As a stop-gap, if we don't have a GPIO line, use an EDID probe to detect connection. Fixes HDMI display on the pi3.
Signed-off-by Eric Anholt <[email protected]>
--- drivers/gpu/drm/vc4/vc4_hdmi.c | 3 +++ 1 file changed, 3 insertions(+)
drivers/gpu/drm/vc4/vc4_hdmi.c +3 -0
@@ -174,6 +174,9 @@ vc4_hdmi_connector_detect(struct drm_connector *connector, bool force)return connector_status_disconnected; } +if (drm_probe_ddc (vc4->hdmi->ddc)) +return connector_status_connected; +if (HDMI_READ (VC4_HDMI_HOTPLUG ) &VC4_HDMI_HOTPLUG_CONNECTED )return connector_status_connected;else
Signature · 6 lines
2.9.3 _______________________________________________ dri-devel mailing list [email protected] https://lists.freedesktop.org/mailman/listinfo/dri-devel