Convert CONFIG_NAND_OMAP_GPMC et al to Kconfig
PATCH v3 1/1 Convert CONFIG_NAND_OMAP_GPMC et al to Kconfig
This converts the following to Kconfig:
CONFIG_NAND_OMAP_GPMC
CONFIG_NAND_OMAP_GPMC_PREFETCH
CONFIG_NAND_OMAP_ELM
CONFIG_SYS_NAND_BUSWIDTH_16BIT
CONFIG_SPL_NAND_AM33XX_BCH
CONFIG_SPL_NAND_SIMPLE (ARCH_OMAP2PLUS only)
V3:
Remove selection from CMD_NAND
Changes since V1:
Rebased on latest Master
Fixed a few missing entries where some features lacked dependancies
--- configs/am3517_crane_defconfig | 6 ++++-- configs/cm_t3517_defconfig | 1 + configs/cm_t35_defconfig | 1 + configs/omap3_evm_defconfig | 1 + configs/omap3_ha_defconfig | 6 ++++-- configs/tao3530_defconfig | 6 ++++-- configs/tricorder_defconfig | 1 + include/configs/ti_omap3_common.h | 1 - 8 files changed, 16 insertions(+), 7 deletions(-)
configs/am3517_crane_defconfig +4 -2
@@ -13,11 +13,11 @@ CONFIG_SYS_PROMPT="AM3517_CRANE # " # CONFIG_CMD_IMI is not set # CONFIG_CMD_IMLS is not set # CONFIG_CMD_FLASH is not set +# CONFIG_CMD_FPGA is not set +CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y CONFIG_CMD_NAND=y -CONFIG_CMD_I2C=y CONFIG_CMD_USB=y -# CONFIG_CMD_FPGA is not set # CONFIG_CMD_SETEXPR is not set # CONFIG_CMD_NET is not set CONFIG_CMD_DHCP=y
@@ -26,6 +26,8 @@ CONFIG_CMD_EXT2=y CONFIG_CMD_FAT=y CONFIG_CMD_JFFS2=y CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y +CONFIG_SYS_NAND_BUSWIDTH_16BIT=y CONFIG_SYS_NS16550=y CONFIG_USB=y CONFIG_USB_STORAGE=y
configs/cm_t3517_defconfig +1 -0
@@ -37,6 +37,7 @@ CONFIG_LED_STATUS_STATE=2 CONFIG_LED_STATUS_BOOT_ENABLE=y CONFIG_LED_STATUS_BOOT=0 CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y CONFIG_SYS_NS16550=y CONFIG_USB=y CONFIG_USB_MUSB_HOST=y
configs/cm_t35_defconfig +1 -0
@@ -39,6 +39,7 @@ CONFIG_LED_STATUS_STATE=2 CONFIG_LED_STATUS_BOOT_ENABLE=y CONFIG_LED_STATUS_BOOT=0 CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y CONFIG_SYS_NS16550=y CONFIG_USB=y CONFIG_USB_EHCI_HCD=y
configs/omap3_evm_defconfig +1 -0
@@ -45,6 +45,7 @@ CONFIG_SPL_DM=y CONFIG_DM_GPIO=y CONFIG_MMC_OMAP_HS=y CONFIG_MTD=y +CONFIG_NAND=y CONFIG_DM_SERIAL=y CONFIG_SYS_NS16550=y CONFIG_USB=y
configs/omap3_ha_defconfig +4 -2
@@ -12,11 +12,11 @@ CONFIG_HUSH_PARSER=y # CONFIG_CMD_IMI is not set # CONFIG_CMD_IMLS is not set # CONFIG_CMD_FLASH is not set +# CONFIG_CMD_FPGA is not set +CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y CONFIG_CMD_NAND=y -CONFIG_CMD_I2C=y CONFIG_CMD_USB=y -# CONFIG_CMD_FPGA is not set # CONFIG_CMD_SETEXPR is not set CONFIG_CMD_DHCP=y CONFIG_CMD_PING=y
@@ -25,6 +25,8 @@ CONFIG_CMD_EXT2=y CONFIG_CMD_FAT=y CONFIG_CMD_MTDPARTS=y CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y +CONFIG_SYS_NAND_BUSWIDTH_16BIT=y CONFIG_SYS_NS16550=y CONFIG_USB=y CONFIG_USB_EHCI_HCD=y
configs/tao3530_defconfig +4 -2
@@ -12,11 +12,11 @@ CONFIG_SYS_PROMPT="TAO-3530 # " # CONFIG_CMD_IMI is not set # CONFIG_CMD_IMLS is not set # CONFIG_CMD_FLASH is not set +# CONFIG_CMD_FPGA is not set +CONFIG_CMD_I2C=y CONFIG_CMD_MMC=y CONFIG_CMD_NAND=y -CONFIG_CMD_I2C=y CONFIG_CMD_USB=y -# CONFIG_CMD_FPGA is not set # CONFIG_CMD_SETEXPR is not set CONFIG_CMD_DHCP=y CONFIG_CMD_PING=y
@@ -25,6 +25,8 @@ CONFIG_CMD_EXT2=y CONFIG_CMD_FAT=y CONFIG_CMD_MTDPARTS=y CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y +CONFIG_SYS_NAND_BUSWIDTH_16BIT=y CONFIG_SYS_NS16550=y CONFIG_USB=y CONFIG_USB_EHCI_HCD=y
configs/tricorder_defconfig +1 -0
@@ -35,5 +35,6 @@ CONFIG_LED_STATUS_BIT2=4 CONFIG_LED_STATUS_STATE2=2 CONFIG_LED_STATUS_CMD=y CONFIG_MMC_OMAP_HS=y +CONFIG_NAND=y CONFIG_SYS_NS16550=y CONFIG_OF_LIBFDT=y
include/configs/ti_omap3_common.h +0 -1
@@ -65,7 +65,6 @@ (64 << 20))#ifdef CONFIG_NAND -#define CONFIG_SPL_NAND_SIMPLE #define CONFIG_SYS_NAND_BASE 0x30000000#endif
Signature · 1 line
2.7.4
PATCH v3 1/1 Convert CONFIG_NAND_OMAP_GPMC et al to Kconfig
Quoted 10 lines · Adam Ford
This converts the following to
Kconfig:
CONFIG_NAND_OMAP_GPMC
CONFIG_NAND_OMAP_GPMC_PREFETCH
CONFIG_NAND_OMAP_ELM
CONFIG_SYS_NAND_BUSWIDTH_16BIT
CONFIG_SPL_NAND_AM33XX_BCH
CONFIG_SPL_NAND_SIMPLE(ARCH_OMAP2PLUSonly)Signed-off-by Adam Ford <[email protected]>
Quoted 7 lines
V3:
Remove selection fromCMD_NANDChanges since V1:
Rebased on latest Master
Fixed a few missing entries where some features lacked dependancies
---
The changelog goes below the '---' :) And more importantly..
Quoted 9 lines
configs/am3517_crane_defconfig | 6 ++++-- configs/cm_t3517_defconfig | 1 + configs/cm_t35_defconfig | 1 + configs/omap3_evm_defconfig | 1 + configs/omap3_ha_defconfig | 6 ++++-- configs/tao3530_defconfig | 6 ++++-- configs/tricorder_defconfig | 1 + include/configs/ti_omap3_common.h | 1 - 8 files changed, 16 insertions(+), 7 deletions(-)
You forgot the Kconfig part of these changes.
Signature · 8 lines
Tom -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 819 bytes Desc: Digital signature URL: <http://lists.denx.de/pipermail/u-boot/attachments/20170901/0986ca29/attachment.sig>
PATCH v3 1/1 Convert CONFIG_NAND_OMAP_GPMC et al to Kconfig
Quoted 32 lines · Tom Rini
Quoted 10 lines · Adam Ford
This converts the following to
Kconfig:
CONFIG_NAND_OMAP_GPMC
CONFIG_NAND_OMAP_GPMC_PREFETCH
CONFIG_NAND_OMAP_ELM
CONFIG_SYS_NAND_BUSWIDTH_16BIT
CONFIG_SPL_NAND_AM33XX_BCH
CONFIG_SPL_NAND_SIMPLE(ARCH_OMAP2PLUSonly)Signed-off-by Adam Ford <[email protected]>Quoted 7 lines
V3:
Remove selection fromCMD_NANDChanges since V1:
Rebased on latest Master
Fixed a few missing entries where some features lacked dependancies
---The changelog goes below the '---' :) And more importantly..
Quoted 9 lines
configs/am3517_crane_defconfig | 6 ++++-- configs/cm_t3517_defconfig | 1 + configs/cm_t35_defconfig | 1 + configs/omap3_evm_defconfig | 1 + configs/omap3_ha_defconfig | 6 ++++-- configs/tao3530_defconfig | 6 ++++-- configs/tricorder_defconfig | 1 + include/configs/ti_omap3_common.h | 1 - 8 files changed, 16 insertions(+), 7 deletions(-)
Quoted 1 line
You forgot the
Kconfigpart of these changes.
My bad. I didn't add the '--amend' to my git commit, so version 2 &3 totally missed the vast majority of what I had in V1. Sorry about that. I just re-sent V4 with everything from V1-V3 combined into 1 patch.
adam
Quoted 3 lines
--
Tom