Skip to contentSkip to conversation

s390x: Switch to z/Arch and enable 64 bit addressing mode

PATCH New Janosch Frank 1 participant 1 message Jan 10, 2019 s390

lore
Share & tools
lore
#0 lore raw

PATCH v5 4/11 s390x: Switch to z/Arch and enable 64 bit addressing mode

LPAR and z/VM start in esam mode depending on the hardware (CZAM facility and others affect this), so we need to switch to z/Arch and set 64 bit addressing.

Under Qemu/KVM we already start out with both when being run with the Qemu --kernel argument or we lack 64 bit when booting from disk because of the initial psw specifying 31 bit for z/VM and lpar compatibility.

---
 s390x/cstart64.S | 11 +++++++++++
 1 file changed, 11 insertions(+)
s390x/cstart64.S +11 -0
index 385915e..6622633 100644
@@ -11,6 +11,7 @@
  * under the terms of the GNU Library General Public License version 2.
  */
 #include <asm/asm-offsets.h>
+#include <asm/sigp.h>
 
 .section .init
 
@@ -20,9 +21,19 @@
  *
  * For KVM and TCG kernel boot we are in 64 bit z/Arch mode.
  * When booting from disk the initial short psw is in 31 bit mode.
+ * When running under LPAR or z/VM, we might start in 31 bit and esam mode.
  */
 	.globl start
 start:
+	/* Switch to z/Architecture mode and 64-bit */
+	slr     %r0, %r0		# Set cpuid to zero
+	lhi     %r1, 2			# mode 2 = esame
+	sigp    %r1, %r0, SIGP_SET_ARCHITECTURE
+	/* XOR all registers with themselves to clear them fully. */
+	.irp i, 0,1,2,3,4,5,6,7,8,9,10,11,12,13,14,15
+	xgr \i,\i
+	.endr
+	sam64				# Set addressing mode to 64 bit
 	/* setup stack */
 	larl	%r15, stackptr
 	/* setup initial PSW mask + control registers*/
Signature · 1 line
2.14.3