ARM: dts: add description of Netgear RN NV+v2 LCD
PATCH 1/1 ARM: dts: add description of Netgear RN NV+v2 LCD
GPIO pin mapping taken from NetGear NV+ v2 5.3.13 kernel sources[1] (see arch/arm/plat-feroceon/mv_hal/rtc/ext_rtc/usiLCD.c).
1. https://www.downloads.netgear.com/files/GPL/RND_5.3.13_WW.src.zip
--- .../boot/dts/kirkwood-netgear_readynas_nv+_v2.dts | 14 ++++++++++++++ 1 file changed, 14 insertions(+)
arch/arm/boot/dts/kirkwood-netgear_readynas_nv+_v2.dts +14 -0
@@ -184,6 +184,20 @@ gpios = <&gpio0 30 GPIO_ACTIVE_LOW>; }; + auxdisplay { + compatible = "hit,hd44780"; + data-gpios = <&gpio0 17 GPIO_ACTIVE_HIGH>, + <&gpio1 1 GPIO_ACTIVE_HIGH>, + <&gpio1 3 GPIO_ACTIVE_HIGH>, + <&gpio1 17 GPIO_ACTIVE_HIGH>; + enable-gpios = <&gpio0 16 GPIO_ACTIVE_HIGH>; + rs-gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>; + rw-gpios = <&gpio0 15 GPIO_ACTIVE_HIGH>; + backlight-gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; + display-height-chars = <2>; + display-width-chars = <16>; + }; + regulators { compatible = "simple-bus"; #address-cells = <1>;
Signature · 1 line
2.17.1
Quoted 2 lines · David Coles
GPIO pin mapping taken from NetGear NV+ v2 5.3.13 kernel sources[1] (see
arch/arm/plat-feroceon/mv_hal/rtc/ext_rtc/usiLCD.c).
Kirkwood! It has been a while since we had a kirkwood patch. Some NAS boxes seem to never die. Nice to see somebody still hacking on them.
Quoted 1 line
Signed-off-by David Coles <[email protected]>
Andrew
Quoted 2 lines · Andrew Lunn
Kirkwood! It has been a while since we had a kirkwood patch. Some NAS boxes seem to never die. Nice to see somebody still hacking on them.
Netgear firmware only supported SMBv1, Windows 10 does not. Luckily Arnaud Ebalard had done most of the heavy lifting years ago. Getting the LCD working with the new HD44780 driver was icing on the cake.
Thanks,
David