dt-bindings: usb: ci-hdrc-usb2: add property power-active-high
Subsystems (2)
PATCH 2/5 dt-bindings: usb: ci-hdrc-usb2: add property power-active-high
From: Philipp Puschmann <[email protected]>
The i.MX USB controller may drive the usb power line directly, but the polarity depends on the board. Reset state of the polarity is low-active so add this property to allow it to be high-active.
Signed-off-by Philipp Puschmann <[email protected]>
Reviewed-by Rob Herring <[email protected]>
Signed-off-by Peter Chen <[email protected]>
--- Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 + 1 file changed, 1 insertion(+)
Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +1 -0
@@ -93,6 +93,7 @@ i.mx specific properties - over-current-active-low: over current signal polarity is active low. - over-current-active-high: over current signal polarity is active high. It's recommended to specify the over current polarity. +- power-active-high: power signal polarity is active high - external-vbus-divider: enables off-chip resistor divider for Vbus Example: