Skip to contentSkip to conversation

dt-bindings: usb: ci-hdrc-usb2: add property power-active-high

PATCH New Peter Chen 1 participant 1 message Feb 27, 2019

Subsystems (2)
lore
Share & tools
lore

Peter Chen

author
#0 lore raw

PATCH 2/5 dt-bindings: usb: ci-hdrc-usb2: add property power-active-high

From: Philipp Puschmann <[email protected]>

The i.MX USB controller may drive the usb power line directly, but the polarity depends on the board. Reset state of the polarity is low-active so add this property to allow it to be high-active.

---
 Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 1 +
 1 file changed, 1 insertion(+)
Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +1 -0
index adae82385dd6..a254386a91ad 100644
@@ -93,6 +93,7 @@ i.mx specific properties
 - over-current-active-low: over current signal polarity is active low.
 - over-current-active-high: over current signal polarity is active high.
   It's recommended to specify the over current polarity.
+- power-active-high: power signal polarity is active high
 - external-vbus-divider: enables off-chip resistor divider for Vbus
 
 Example: