ARM: dts: sun8i-h3: Add support for the RerVision H3-DVK board
Subsystems (3)
PATCH v3 1/1 ARM: dts: sun8i-h3: Add support for the RerVision H3-DVK board
This is an H3-based board that sticks close to the reference design.
Supported features:
* UART
* DRAM
* MMC
* eMMC
* Ethernet
* USB host
* USB peripheral
* HDMI
Signed-off-by Paul Kocialkowski <[email protected]>
---
Changes since v2:
* Actually made the changes instead of sending the same patch again.
Changes since v1:
* Removed unneeded changes to mmc2_8bit_pins node;
* Renamed HDMI connector nodes to match other boards.
arch/arm/boot/dts/Makefile | 1 + arch/arm/boot/dts/sun8i-h3-rervision-dvk.dts | 114 +++++++++++++++++++ 2 files changed, 115 insertions(+) create mode 100644 arch/arm/boot/dts/sun8i-h3-rervision-dvk.dts
arch/arm/boot/dts/Makefile +1 -0
@@ -1078,6 +1078,7 @@ dtb-$(CONFIG_MACH_SUN8I) += \ sun8i-h3-orangepi-plus.dtb \ sun8i-h3-orangepi-plus2e.dtb \ sun8i-h3-orangepi-zero-plus2.dtb \ + sun8i-h3-rervision-dvk.dtb \ sun8i-r16-bananapi-m2m.dtb \ sun8i-r16-nintendo-nes-classic.dtb \ sun8i-r16-nintendo-super-nes-classic.dtb \
arch/arm/boot/dts/sun8i-h3-rervision-dvk.dts new file +114 -0
114 lines not on this page · raw message
Signature · 1 line
2.21.0
Maxime Ripard
AppliedQuoted 12 lines · Paul Kocialkowski
This is an H3-based board that sticks close to the reference design.
Supported features:
* UART
* DRAM
* MMC
* eMMC
* Ethernet
* USB host
* USB peripheral
* HDMI
Quoted 1 line
Signed-off-by Paul Kocialkowski <[email protected]>
Applied, thanks!
Maxime
Signature · 3 lines
Maxime Ripard, Bootlin Embedded Linux and Kernel engineering https://bootlin.com