Skip to contentSkip to conversation

ARM: dts: sun8i: a33: Add default address and size cells to the DSI node

PATCH In review Maxime Ripard 2 participants 3 messages Mar 18, 2019 – Mar 19, 2019

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: dts: sun8i: a33: Add default address and size cells to the DSI node

The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.

---
 arch/arm/boot/dts/sun8i-a33.dtsi | 2 ++
 1 file changed, 2 insertions(+)
arch/arm/boot/dts/sun8i-a33.dtsi +2 -0
index 1111a6498102..9f09e2996f1e 100644
@@ -265,6 +265,8 @@
 			phys = <&dphy>;
 			phy-names = "dphy";
 			status = "disabled";
+			#address-cells = <1>;
+			#size-cells = <0>;
 
 			ports {
 				#address-cells = <1>;
Signature · 7 lines
2.20.1


_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Acked-by on v1 1/1
#1 lore raw
Quoted 6 lines · Maxime Ripard

The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.

_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel

author Applied
#2 lore raw
Quoted 9 lines · Chen-Yu Tsai
Quoted 6 lines · Maxime Ripard

The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.

Applied, thanks!
Maxime

--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com

_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel