ARM: dts: sun8i: a33: Add default address and size cells to the DSI node
Subsystems (2)
PATCH 1/1 ARM: dts: sun8i: a33: Add default address and size cells to the DSI node
The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.
--- arch/arm/boot/dts/sun8i-a33.dtsi | 2 ++ 1 file changed, 2 insertions(+)
arch/arm/boot/dts/sun8i-a33.dtsi +2 -0
@@ -265,6 +265,8 @@ phys = <&dphy>; phy-names = "dphy"; status = "disabled"; + #address-cells = <1>; + #size-cells = <0>; ports { #address-cells = <1>;
Signature · 7 lines
2.20.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Quoted 6 lines · Maxime Ripard
The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.Signed-off-by Maxime Ripard <[email protected]>
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Maxime Ripard
AppliedQuoted 9 lines · Chen-Yu Tsai
Quoted 6 lines · Maxime Ripard
The DSI bindings require that an address cell size of 1, and a size cell of
0. Instead of duplicating it in each and every board DTS file, let's put it in the DTSI.Signed-off-by Maxime Ripard <[email protected]>Acked-by Chen-Yu Tsai <[email protected]>
Applied, thanks!
Maxime
--
Maxime Ripard, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
_______________________________________________
linux-arm-kernel mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel