boards: amlogic-g200: remove phy reset
PATCH 1/1 boards: amlogic-g200: remove phy reset
The PHY reset is now handled by the MAC driver, remove this leftover.
Signed-off-by Neil Armstrong <[email protected]>
--- board/amlogic/q200/q200.c | 6 ------ 1 file changed, 6 deletions(-)
board/amlogic/q200/q200.c +0 -6
@@ -26,12 +26,6 @@ int misc_init_r(void)meson_eth_init (PHY_INTERFACE_MODE_RGMII ,0 ); -/* Reset PHY on GPIOZ_14 */ -clrbits_le32 (GX_GPIO_EN (3 ),BIT (14 )); -clrbits_le32 (GX_GPIO_OUT (3 ),BIT (14 )); -mdelay (10 ); -setbits_le32 (GX_GPIO_OUT (3 ),BIT (14 )); -if (!eth_env_get_enetaddr ("ethaddr" , mac_addr)) { len =meson_sm_read_efuse (EFUSE_MAC_OFFSET , mac_addr,EFUSE_MAC_SIZE );
Signature · 1 line
2.21.0
PATCH 1/1 boards: amlogic-g200: remove phy reset
Quoted 15 lines · Neil Armstrong
The PHY reset is now handled by the MAC driver, remove this leftover.
Signed-off-by Neil Armstrong <[email protected]>--- board/amlogic/q200/q200.c | 6 ------ 1 file changed, 6 deletions(-)board/amlogic/q200/q200.c +0
-0@@ -26,12 +26,6 @@ int misc_init_r(void)meson_eth_init (PHY_INTERFACE_MODE_RGMII ,0 );
board/amlogic/q200/q200.c int misc_init_r(void) · line 31
Quoted 10 lines
board/amlogic/q200/q200.c +0
-6-/* Reset PHY on GPIOZ_14 */ -clrbits_le32 (GX_GPIO_EN (3 ),BIT (14 )); -clrbits_le32 (GX_GPIO_OUT (3 ),BIT (14 )); -mdelay (10 ); -setbits_le32 (GX_GPIO_OUT (3 ),BIT (14 )); -if (!eth_env_get_enetaddr ("ethaddr" , mac_addr)) { len =meson_sm_read_efuse (EFUSE_MAC_OFFSET , mac_addr,EFUSE_MAC_SIZE );
Applied to u-boot-amlogic