arm64: Enable reset and pinctrl for ARCH_BRCMSTB
cover arm64: Enable reset and pinctrl for ARCH_BRCMSTB
This patch series enabled PINCTRL and ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB since we have platforms that require these two subsystems.
Doug Berger (1):
arm64: Enable PINCTRL for ARCH_BRCMSTB
Jim Quinlan (1):
arm64: Enable ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB
arch/arm64/Kconfig.platforms | 2 ++ 1 file changed, 2 insertions(+)
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 1/2 arm64: Enable ARCH_HAS_RESET_CONTROLLER for ARCH_BRCMSTB
From: Jim Quinlan <[email protected]>
Allow the use of reset controllers on ARCH_BRCMSTB such as the recently introduced RESET_BRCMSTB driver.
--- arch/arm64/Kconfig.platforms | 1 + 1 file changed, 1 insertion(+)
arch/arm64/Kconfig.platforms +1 -0
@@ -65,6 +65,7 @@ config ARCH_BITMAIN config ARCH_BRCMSTB bool "Broadcom Set-Top-Box SoCs" + select ARCH_HAS_RESET_CONTROLLER select BCM7038_L1_IRQ select BRCMSTB_L2_IRQ select GENERIC_IRQ_CHIP
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
PATCH 2/2 arm64: Enable PINCTRL for ARCH_BRCMSTB
In reply to Florian FainelliFrom: Doug Berger <[email protected]>
ARCH_BRCMSTB needs to use the BCM2835 pin controller for chips like BCM7211 which adopted that pin controller for GPIO.
--- arch/arm64/Kconfig.platforms | 1 + 1 file changed, 1 insertion(+)
arch/arm64/Kconfig.platforms +1 -0
@@ -69,6 +69,7 @@ config ARCH_BRCMSTB select BCM7038_L1_IRQ select BRCMSTB_L2_IRQ select GENERIC_IRQ_CHIP + select PINCTRL help This enables support for Broadcom's ARMv8 Set Top Box SoCs
Signature · 7 lines
2.17.1 _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
Quoted 8 lines · Florian Fainelli
This patch series enabled PINCTRL and
ARCH_HAS_RESET_CONTROLLERforARCH_BRCMSTBsince we have platforms that require these two subsystems.Doug Berger (1):
arm64: Enable PINCTRL forARCH_BRCMSTBJim Quinlan (1):
arm64: EnableARCH_HAS_RESET_CONTROLLERforARCH_BRCMSTB
Series applied to soc-arm64/next, thanks!
Signature · 6 lines
Florian _______________________________________________ linux-arm-kernel mailing list [email protected] http://lists.infradead.org/mailman/listinfo/linux-arm-kernel