Skip to contentSkip to conversation

ARM: imx6: DHCOM i.MX6 PDK: enable pad pull ups of SS lines of spi used for boot

PATCH New Ludwig Zenz 2 participants 2 messages Jul 1, 2019 – Jul 20, 2019 Arm i.MX and Layerscape

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ARM: imx6: DHCOM i.MX6 PDK: enable pad pull ups of SS lines of spi used for boot

It turned out that after a reset the boot process from the spi bootflash is disturbed by other spi slave devices connected to DHCOM SPI1, which uses the same spi interface with a different SS line.

Therefore the pad pull ups are enabled.

---
 board/dhelectronics/dh_imx6/dh_imx6_spl.c | 9 +++++++--
 1 file changed, 7 insertions(+), 2 deletions(-)
board/dhelectronics/dh_imx6/dh_imx6_spl.c +7 -2
index 2939389de3..9494d2d6a3 100644
@@ -440,8 +440,13 @@ static void setup_iomux_sd(void)
 
 /* SPI */
 static iomux_v3_cfg_t const ecspi1_pads[] = {
-	/* SS0 */
-	IOMUX_PADS(PAD_EIM_EB2__GPIO2_IO30	| MUX_PAD_CTRL(SPI_PAD_CTRL)),
+	/* SS0 - SS of boot flash */
+	IOMUX_PADS(PAD_EIM_EB2__GPIO2_IO30	|
+		MUX_PAD_CTRL(SPI_PAD_CTRL | PAD_CTL_PUS_100K_UP)),
+	/* SS2 - SS of DHCOM SPI1 */
+	IOMUX_PADS(PAD_KEY_ROW2__GPIO4_IO11	|
+		MUX_PAD_CTRL(SPI_PAD_CTRL | PAD_CTL_PUS_100K_UP)),
+
 	IOMUX_PADS(PAD_EIM_D17__ECSPI1_MISO	| MUX_PAD_CTRL(SPI_PAD_CTRL)),
 	IOMUX_PADS(PAD_EIM_D18__ECSPI1_MOSI	| MUX_PAD_CTRL(SPI_PAD_CTRL)),
 	IOMUX_PADS(PAD_EIM_D16__ECSPI1_SCLK	| MUX_PAD_CTRL(SPI_PAD_CTRL)),
Signature · 1 line
2.11.0
#1 lore raw

PATCH 1/1 ARM: imx6: DHCOM i.MX6 PDK: enable pad pull ups of SS lines of spi used for boot

Quoted 5 lines

It turned out that after a reset the boot process from the spi bootflash is disturbed by other spi slave devices connected to DHCOM SPI1, which uses the same spi interface with a different SS line.
Therefore the pad pull ups are enabled.

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================