rockchip: rk3399: derive ethaddr from cpuid
Subsystems (3)
PATCH 1/3 rockchip: rk3399: derive ethaddr from cpuid
Generate a MAC address based on the cpuid available in the efuse
block: Use the first 6 byte of the cpuid's SHA256 hash and set the locally administered bits. Also ensure that the multicast bit is cleared.
The MAC address is only generated and set if there is no ethaddr present in the saved environment.
This is based off of Klaus Goger's work in 8adc9d
---
arch/arm/include/asm/arch-rockchip/misc.h | 13 +++ arch/arm/mach-rockchip/Makefile | 2 + arch/arm/mach-rockchip/misc.c | 108 ++++++++++++++++++++++ board/rockchip/evb_rk3399/evb-rk3399.c | 13 +++ 4 files changed, 136 insertions(+) create mode 100644 arch/arm/include/asm/arch-rockchip/misc.h create mode 100644 arch/arm/mach-rockchip/misc.c
arch/arm/include/asm/arch-rockchip/misc.h new file +13 -0
@@ -0,0 +1,13 @@ +/* SPDX-License-Identifier: GPL-2.0+ */ +/* +* RK3399: Architecture common definitions +* +* Copyright (C) 2019 Collabora Inc - https://www.collabora.com/ +* Rohan Garg <[email protected]> +*/ + +void rockchip_cpuid_from_efuse (const u32 cpuid_offset, +const u32 cpuid_length, +u8 *cpuid); +void rockchip_cpuid_set (const u8 *cpuid,const u32 cpuid_length); +void rockchip_setup_macaddr (void );
arch/arm/mach-rockchip/Makefile +2 -0
@@ -47,6 +47,8 @@ obj-y += rk_timer.o endif endif +obj-y += misc.o + obj-$(CONFIG_ROCKCHIP_RK3036) += rk3036/ obj-$(CONFIG_ROCKCHIP_RK3128) += rk3128/ ifndef CONFIG_TPL_BUILD
arch/arm/mach-rockchip/misc.c new file +108 -0
108 lines not on this page · raw message
board/rockchip/evb_rk3399/evb-rk3399.c +13 -0
@@ -7,6 +7,7 @@#include <dm.h> #include <dm/pinctrl.h> #include <asm/arch-rockchip/periph.h> +#include <asm/arch-rockchip/misc.h> #include <power/regulator.h> int board_init (void )
@@ -33,3 +34,15 @@ int board_init(void) out:return 0 ; } + +int misc_init_r (void ) +{ +const u32 cpuid_offset =0x7 ; +const u32 cpuid_length =0x10 ; +u8 cpuid[cpuid_length]; + +rockchip_cpuid_from_efuse (cpuid_offset, cpuid_length, cpuid); +rockchip_cpuid_set (cpuid, cpuid_length); +rockchip_setup_macaddr (); +return 0 ; +}
Signature · 1 line
2.17.1
PATCH 2/3 rockchip: rk3399: Enable CONFIG_MISC_INIT_R for the Rock PI 4
This enables us to set a static MAC address
---
configs/rock-pi-4-rk3399_defconfig | 1 + 1 file changed, 1 insertion(+)
configs/rock-pi-4-rk3399_defconfig +1 -0
@@ -58,3 +58,4 @@ CONFIG_USB_ETHER_SMSC95XX=y CONFIG_USE_TINY_PRINTF=y CONFIG_SPL_TINY_MEMSET=y CONFIG_ERRNO_STR=y +CONFIG_MISC_INIT_R=y
Signature · 1 line
2.17.1
PATCH 3/3 board: puma: Use rockchip_* helpers to setup cpuid and macaddr
In reply to Rohan Garg---
.../puma_rk3399/puma-rk3399.c | 98 ++----------------- 1 file changed, 8 insertions(+), 90 deletions(-)
board/theobroma-systems/puma_rk3399/puma-rk3399.c +8 -90
@@ -17,6 +17,7 @@#include <asm/arch-rockchip/clock.h> #include <asm/arch-rockchip/hardware.h> #include <asm/arch-rockchip/grf_rk3399.h> +#include <asm/arch-rockchip/misc.h> #include <asm/arch-rockchip/periph.h> #include <power/regulator.h> #include <u-boot/sha256.h>
@@ -36,94 +37,6 @@ int board_init(void)return 0 ; } -static void setup_macaddr (void ) -{ -#if CONFIG_IS_ENABLED (CMD_NET ) -int ret; -const char *cpuid =env_get ("cpuid#" ); -u8 hash[SHA256_SUM_LEN ]; -int size =sizeof (hash); -u8 mac_addr[6 ]; - -/* Only generate a MAC address, if none is set in the environment */ -if (env_get ("ethaddr" )) -return ; - -if (!cpuid) { -debug ("%s: could not retrieve 'cpuid#'\n" , __func__); -return ; - } - - ret =hash_block ("sha256" , (void *)cpuid,strlen (cpuid), hash, &size); -if (ret) { -debug ("%s: failed to calculate SHA256\n" , __func__); -return ; - } - -/* Copy 6 bytes of the hash to base the MAC address on */ -memcpy (mac_addr, hash,6 ); - -/* Make this a valid MAC address and set it */ - mac_addr[0 ] &=0xfe ;/* clear multicast bit */ - mac_addr[0 ] |=0x02 ;/* set local assignment bit (IEEE802) */ -eth_env_set_enetaddr ("ethaddr" , mac_addr); -#endif -} - -static void setup_serial (void ) -{ -#if CONFIG_IS_ENABLED (ROCKCHIP_EFUSE ) -const u32 cpuid_offset =0x7 ; -const u32 cpuid_length =0x10 ; - -struct udevice *dev; -int ret, i; -u8 cpuid[cpuid_length]; -u8 low[cpuid_length/2 ], high[cpuid_length/2 ]; -char cpuid_str[cpuid_length *2 +1 ]; -u64 serialno; -char serialno_str[17 ]; - -/* retrieve the device */ - ret =uclass_get_device_by_driver (UCLASS_MISC , -DM_GET_DRIVER (rockchip_efuse), &dev); -if (ret) { -debug ("%s: could not find efuse device\n" , __func__); -return ; - } - -/* read the cpu_id range from the efuses */ - ret =misc_read (dev, cpuid_offset, &cpuid,sizeof (cpuid)); -if (ret) { -debug ("%s: reading cpuid from the efuses failed\n" , - __func__); -return ; - } - -memset (cpuid_str,0 ,sizeof (cpuid_str)); -for (i =0 ; i <16 ; i++) -sprintf (&cpuid_str[i *2 ],"%02x" , cpuid[i]); - -debug ("cpuid: %s\n" , cpuid_str); - -/* -* Mix the cpuid bytes using the same rules as in -* ${linux}/drivers/soc/rockchip/rockchip-cpuinfo.c -*/ -for (i =0 ; i <8 ; i++) { - low[i] = cpuid[1 + (i <<1 )]; - high[i] = cpuid[i <<1 ]; - } - - serialno =crc32_no_comp (0 , low,8 ); - serialno |= (u64 )crc32_no_comp (serialno, high,8 ) <<32 ; -snprintf (serialno_str,sizeof (serialno_str),"%016llx" , serialno); - -env_set ("cpuid#" , cpuid_str); -env_set ("serial#" , serialno_str); -#endif -} -static void setup_iodomain (void ) {const u32 GRF_IO_VSEL_GPIO4CD_SHIFT =3 ;
@@ -213,8 +126,13 @@ static int setup_boottargets(void)int misc_init_r (void ) { -setup_serial (); -setup_macaddr (); +const u32 cpuid_offset =0x7 ; +const u32 cpuid_length =0x10 ; +u8 cpuid[cpuid_length]; + +rockchip_cpuid_from_efuse (cpuid_offset, cpuid_length, cpuid); +rockchip_cpuid_set (cpuid, cpuid_length); +rockchip_setup_macaddr ();setup_iodomain ();setup_boottargets ();
Signature · 1 line
2.17.1
PATCH 3/3 board: puma: Use rockchip_* helpers to setup cpuid and macaddr
Quoted 5 lines · Rohan Garg
Signed-off-by Rohan Garg <[email protected]>
Your commit message is empty on this one.
Please revise.
Thanks,
Philipp.