Skip to contentSkip to conversation

mx7ulp_evk: Update DDR freq to 352.8Mhz for ULP B0

PATCH New sbabic at denx.de 1 participant 1 message Jul 20, 2019

lore
Share & tools
lore
#0 lore raw

PATCH 5/5 mx7ulp_evk: Update DDR freq to 352.8Mhz for ULP B0

Quoted 17 lines

From: Ye Li <[email protected]>
On i.MX7ULP B0, the DDR clock target is increased from 320Mhz to 380Mhz. We update DDR clock relevant settings to approach the target. But since the limitation on LCDIF pix clock for HDMI output
(refer "mx7ulp_evk: Change APLL and its PFD0 frequencies"), we set DDR clock to 352.8Mhz (25.2Mhz * 14) by using the clock path:

	APLL PFD0 -> DDR CLK -> NIC0 -> NIC1 -> LCDIF clock
To reduce the impact to entire system, the NIC0_DIV and NIC1_DIV are kept,
so the divider 14 is calculated as:
	14 = (NIC0_DIV + 1) * (NIC1_DIV + 1) * (LCDIF_PCC_DIV + 1)
	NIC0_DIV:      1
	NIC1_DIV:      0
	LCDIF_PCC_DIV: 6
APLL and APLL PFD0 settings:
	PFD0 FRAC:  27
	APLL MULT:  22
	APLL NUM:   1
Quoted 6 lines

APLL DENOM: 20
This patch applies the new settings for both DCD and plugin. There is no DDR script change on this new frequency. Overnight memtester is passed.

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

Signature · 5 lines
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================