Skip to contentSkip to conversation

rtc: add new Amlogic Virtual Wake RTC

PATCH Applied Kevin Hilman 3 participants 6 messages Aug 12, 2019 – Aug 22, 2019

Subsystems (3)
lore
Share & tools
lore
#0 lore raw

v3 cover rtc: add new Amlogic Virtual Wake RTC

From: Kevin Hilman <[email protected]>

Add a new driver for the virtual wake RTC on Amlogic SoCs.

The RTC is virtual from the Linux side because it's a hardware timer managed by firmware on the secure co-processor (SCP.) The interface is 1 register where a wakeup time (in seconds) is written. The SCP then uses this value to program an always-on timer.

Changes since v2:
- switch to devm_platform_ioremap_resource()
- switch to devm_rtc_allocate_device() and rtc_register_device()

Changes since v1:
- add MAINTAINERS entry
- add nop ->alarm_irq_enable() (workaround for RTC core limitation pointed out by Alexandre Belloni)
- remove unused ->read_alarm()
- fix statics
- move resume to dev_pm_ops
- add suspend hook
- don't calculate (or write) the alarm timer value until suspend time

Changes since Neil's original version
- move from do_gettimeofday() to ktime_get()

Kevin Hilman (1):
dt-bindings: rtc: new binding for Amlogic VRTC

Neil Armstrong (1):
rtc: Add Amlogic Virtual Wake RTC

 .../bindings/rtc/rtc-meson-vrtc.txt           |  22 +++
 MAINTAINERS                                   |   1 +
 drivers/rtc/Kconfig                           |  11 ++
 drivers/rtc/Makefile                          |   1 +
 drivers/rtc/rtc-meson-vrtc.c                  | 156 ++++++++++++++++++
 5 files changed, 191 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/rtc/rtc-meson-vrtc.txt
 create mode 100644 drivers/rtc/rtc-meson-vrtc.c
Signature · 1 line
2.22.0
#1 lore raw

PATCH v3 1/2 dt-bindings: rtc: new binding for Amlogic VRTC

From: Kevin Hilman <[email protected]>

Add binding fo the new VRTC driver for Amlogic SoCs. The 64-bit family of SoCs only has an RTC managed by firmware, and this VRTC driver provides the simple, one-register firmware interface.

---
 .../bindings/rtc/rtc-meson-vrtc.txt           | 22 +++++++++++++++++++
 1 file changed, 22 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/rtc/rtc-meson-vrtc.txt
Documentation/devicetree/bindings/rtc/rtc-meson-vrtc.txt new file +22 -0
new file mode 100644
index 000000000000..c014f54a9853
@@ -0,0 +1,22 @@
+* Amlogic Virtual RTC (VRTC)
+
+This is a Linux interface to an RTC managed by firmware, hence it's
+virtual from a Linux perspective.  The interface is 1 register where
+an alarm time (in seconds) is to be written.
+
+Required properties:
+- compatible: should be "amlogic,meson-vrtc"
+- reg: physical address for the alarm register
+
+The alarm register is a simple scratch register shared between the
+application processors (AP) and the secure co-processor (SCP.)  When
+the AP suspends, the SCP will use the value of this register to
+program an always-on timer before going sleep. When the timer expires,
+the SCP will wake up and will then wake the AP.
+
+Example:
+
+	vrtc: rtc@0a8 {
+		compatible = "amlogic,meson-vrtc";
+		reg = <0x0 0x000a8 0x0 0x4>;
+	};
Signature · 1 line
2.22.0
maintainer Applied
#2 lore raw

Re: [PATCH v3 1/2] dt-bindings: rtc: new binding for Amlogic VRTC

Quoted 6 lines · Kevin Hilman

From: Kevin Hilman <[email protected]>

Add binding fo the new VRTC driver for Amlogic SoCs. The 64-bit family of SoCs only has an RTC managed by firmware, and this VRTC driver provides the simple, one-register firmware interface.

Quoted 7 lines
---
 .../bindings/rtc/rtc-meson-vrtc.txt           | 22 +++++++++++++++++++
 1 file changed, 22 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/rtc/rtc-meson-vrtc.txt

Applied, thanks.

Signature · 3 lines
Alexandre Belloni, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
#3 lore raw

PATCH v3 2/2 rtc: Add Amlogic Virtual Wake RTC

In reply to Kevin Hilman

From: Neil Armstrong <[email protected]>

The Amlogic Meson GX SoCs uses a special register to store the time in seconds to wakeup after a system suspend.

In order to be able to reuse the RTC wakealarm feature, this driver implements a fake RTC device which uses the system time to deduce a suspend delay.

[khilman: rebase to v5.3-rc, rework and modernization]
---
 MAINTAINERS                  |   1 +
 drivers/rtc/Kconfig          |  11 +++
 drivers/rtc/Makefile         |   1 +
 drivers/rtc/rtc-meson-vrtc.c | 156 +++++++++++++++++++++++++++++++++++
 4 files changed, 169 insertions(+)
 create mode 100644 drivers/rtc/rtc-meson-vrtc.c
MAINTAINERS +1 -0
index 783569e3c4b4..2ae83e1acb05 100644
@@ -1443,6 +1443,7 @@ F:	arch/arm64/boot/dts/amlogic/
 F:	drivers/pinctrl/meson/
 F:	drivers/mmc/host/meson*
 F:	drivers/soc/amlogic/
+F:	drivers/rtc/rtc-meson*
 N:	meson
 
 ARM/Amlogic Meson SoC Sound Drivers
drivers/rtc/Kconfig +11 -0
index e72f65b61176..7cd325ecc10b 100644
@@ -373,6 +373,17 @@ config RTC_DRV_MAX77686
 	  This driver can also be built as a module. If so, the module
 	  will be called rtc-max77686.
 
+config RTC_DRV_MESON_VRTC
+	tristate "Amlogic Meson Virtual RTC"
+	depends on ARCH_MESON || COMPILE_TEST
+	default m if ARCH_MESON
+	help
+	  If you say yes here you will get support for the
+	  Virtual RTC of Amlogic SoCs.
+
+	  This driver can also be built as a module. If so, the module
+	  will be called rtc-meson-vrtc.
+
 config RTC_DRV_RK808
 	tristate "Rockchip RK805/RK808/RK809/RK817/RK818 RTC"
 	depends on MFD_RK808
drivers/rtc/Makefile +1 -0
index 6b09c21dc1b6..b50fd3aa81b3 100644
@@ -102,6 +102,7 @@ obj-$(CONFIG_RTC_DRV_MAX8907)	+= rtc-max8907.o
 obj-$(CONFIG_RTC_DRV_MAX8925)	+= rtc-max8925.o
 obj-$(CONFIG_RTC_DRV_MAX8997)	+= rtc-max8997.o
 obj-$(CONFIG_RTC_DRV_MAX8998)	+= rtc-max8998.o
+obj-$(CONFIG_RTC_DRV_MESON_VRTC)+= rtc-meson-vrtc.o
 obj-$(CONFIG_RTC_DRV_MC13XXX)	+= rtc-mc13xxx.o
 obj-$(CONFIG_RTC_DRV_MCP795)	+= rtc-mcp795.o
 obj-$(CONFIG_RTC_DRV_MESON)	+= rtc-meson.o
drivers/rtc/rtc-meson-vrtc.c new file +156 -0

156 lines not on this page · raw message

Signature · 1 line
2.22.0
maintainer Applied
#4 lore raw

Re: [PATCH v3 2/2] rtc: Add Amlogic Virtual Wake RTC

Quoted 12 lines · Kevin Hilman

From: Neil Armstrong <[email protected]>

The Amlogic Meson GX SoCs uses a special register to store the time in seconds to wakeup after a system suspend.

In order to be able to reuse the RTC wakealarm feature, this driver implements a fake RTC device which uses the system time to deduce a suspend delay.

[khilman: rebase to v5.3-rc, rework and modernization]
Quoted 8 lines
---
 MAINTAINERS                  |   1 +
 drivers/rtc/Kconfig          |  11 +++
 drivers/rtc/Makefile         |   1 +
 drivers/rtc/rtc-meson-vrtc.c | 156 +++++++++++++++++++++++++++++++++++
 4 files changed, 169 insertions(+)
 create mode 100644 drivers/rtc/rtc-meson-vrtc.c

Applied, thanks.

Signature · 3 lines
Alexandre Belloni, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com
maintainer
#5 lore raw
In reply to Kevin Hilman
Quoted 8 lines · Kevin Hilman

From: Kevin Hilman <[email protected]>

Add a new driver for the virtual wake RTC on Amlogic SoCs.

The RTC is virtual from the Linux side because it's a hardware timer managed by firmware on the secure co-processor (SCP.) The interface is 1 register where a wakeup time (in seconds) is written. The SCP then uses this value to program an always-on timer.

Just FYI... this was originally tested on G12A and G12B SoCs, but has now also been tested to work unmodified on the new SM1 SoC as well.

Kevin