Skip to contentSkip to conversation

PCI/PM: Note that PME can be generated from D0

PATCH In review Bjorn Helgaas 2 participants 2 messages Oct 16, 2019 – Oct 17, 2019

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 PCI/PM: Note that PME can be generated from D0

From: Bjorn Helgaas <[email protected]>

Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update Documentation/power/pci.rst to reflect that.

---
 Documentation/power/pci.rst | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/power/pci.rst +2 -2
index db41a770a2f5..a90e82c70a3b 100644
@@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the
 device by hardware just as at initial power up.
 
 PCI devices supporting the PCI PM Spec can be programmed to generate PMEs
-while in a low-power state (D1-D3), but they are not required to be capable
-of generating PMEs from all supported low-power states.  In particular, the
+while in any power state (D0-D3), but they are not required to be capable
+of generating PMEs from all supported power states.  In particular, the
 capability of generating PMEs from D3cold is optional and depends on the
 presence of additional voltage (3.3Vaux) allowing the device to remain
 sufficiently active to generate a wakeup signal.
Signature · 1 line
2.23.0.700.g56cf767bdb-goog
maintainer Reviewed-by on v1 1/1
#1 lore raw
Quoted 7 lines · Bjorn Helgaas

From: Bjorn Helgaas <[email protected]>

Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update Documentation/power/pci.rst to reflect that.

Good catch:

Quoted 22 lines
---
 Documentation/power/pci.rst | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/power/pci.rst +2 -3
index db41a770a2f5..a90e82c70a3b 100644
@@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the
 device by hardware just as at initial power up.
 
 PCI devices supporting the PCI PM Spec can be programmed to generate PMEs
-while in a low-power state (D1-D3), but they are not required to be capable
-of generating PMEs from all supported low-power states.  In particular, the
+while in any power state (D0-D3), but they are not required to be capable
+of generating PMEs from all supported power states.  In particular, the
 capability of generating PMEs from D3cold is optional and depends on the
 presence of additional voltage (3.3Vaux) allowing the device to remain
 sufficiently active to generate a wakeup signal.
--

2.23.0.700.g56cf767bdb-goog