PCI/PM: Note that PME can be generated from D0
Subsystems (2)
PATCH 1/1 PCI/PM: Note that PME can be generated from D0
From: Bjorn Helgaas <[email protected]>
Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update Documentation/power/pci.rst to reflect that.
Signed-off-by Bjorn Helgaas <[email protected]>
--- Documentation/power/pci.rst | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
Documentation/power/pci.rst +2 -2
@@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the device by hardware just as at initial power up. PCI devices supporting the PCI PM Spec can be programmed to generate PMEs -while in a low-power state (D1-D3), but they are not required to be capable -of generating PMEs from all supported low-power states. In particular, the +while in any power state (D0-D3), but they are not required to be capable +of generating PMEs from all supported power states. In particular, the capability of generating PMEs from D3cold is optional and depends on the presence of additional voltage (3.3Vaux) allowing the device to remain sufficiently active to generate a wakeup signal.
Signature · 1 line
2.23.0.700.g56cf767bdb-goog
Quoted 7 lines · Bjorn Helgaas
From: Bjorn Helgaas <[email protected]>
Per PCIe r5.0 sec 7.5.2.1, PME may be generated from D0, so update
Documentation/power/pci.rstto reflect that.Signed-off-by Bjorn Helgaas <[email protected]>
Good catch:
Reviewed-by Rafael J. Wysocki <[email protected]>
Quoted 22 lines
--- Documentation/power/pci.rst | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)Documentation/power/pci.rst +2
-3@@ -130,8 +130,8 @@ a full power-on reset sequence and the power-on defaults are restored to the device by hardware just as at initial power up. PCI devices supporting the PCI PM Spec can be programmed to generate PMEs -while in a low-power state (D1-D3), but they are not required to be capable -of generating PMEs from all supported low-power states. In particular, the +while in any power state (D0-D3), but they are not required to be capable +of generating PMEs from all supported power states. In particular, the capability of generating PMEs from D3cold is optional and depends on the presence of additional voltage (3.3Vaux) allowing the device to remain sufficiently active to generate a wakeup signal. --2.23.0.700.g56cf767bdb-goog