dts: Disable DMA support on the BK4 vf610 device's fsl_lpuart driver
PATCH v2 1/1 dts: Disable DMA support on the BK4 vf610 device's fsl_lpuart driver
This change disables the DMA support (RX/TX) on the NXP's fsl_lpuart driver - the PIO mode is used instead. This change is necessary for better robustness of BK4's device use cases with many potentially interrupted short serial transfers.
Without it the driver hangs when some distortion happens on UART lines.
---
Changes for v2:
- Use /delete-property/dma-names; instead of dma-names = "","";
--- arch/arm/boot/dts/vf610-bk4.dts | 4 ++++ 1 file changed, 4 insertions(+)
arch/arm/boot/dts/vf610-bk4.dts +4 -0
@@ -259,24 +259,28 @@ &uart0 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart0>; + /delete-property/dma-names; status = "okay"; }; &uart1 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart1>; + /delete-property/dma-names; status = "okay"; }; &uart2 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart2>; + /delete-property/dma-names; status = "okay"; }; &uart3 { pinctrl-names = "default"; pinctrl-0 = <&pinctrl_uart3>; + /delete-property/dma-names; status = "okay"; };
Signature · 1 line
2.20.1
Quoted 9 lines · Lukasz Majewski
This change disables the DMA support (RX/TX) on the NXP's
fsl_lpuartdriver - the PIO mode is used instead. This change is necessary for better robustness of BK4's device use cases with many potentially interrupted short serial transfers.Without it the driver hangs when some distortion happens on UART lines.
Signed-off-by Lukasz Majewski <[email protected]>Suggested-by Robin Murphy <[email protected]>
Subject prefix should be 'ARM: dts: ...'. I fixed it up and applied the patch.
Shawn
Hi Shawn,
Quoted 9 lines · Lukasz Majewski
Quoted 8 lines
This change disables the DMA support (RX/TX) on the NXP's
fsl_lpuartdriver - the PIO mode is used instead. This change is necessary for better robustness of BK4's device use cases with many potentially interrupted short serial transfers.Without it the driver hangs when some distortion happens on UART lines.
Quoted 7 lines
Quoted 2 lines
Signed-off-by Lukasz Majewski <[email protected]>Suggested-by Robin Murphy <[email protected]>Subject prefix should be 'ARM: dts: ...'. I fixed it up and applied the patch.
Shawn
Thanks :-)
Best regards,
Lukasz Majewski
--
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-59 Fax: (+49)-8142-66989-80 Email: [email protected]