ARM: stm32: Enable bootd, iminfo, imxtract on DHCOM
Subsystems (2)
PATCH 1/1 ARM: stm32: Enable bootd, iminfo, imxtract on DHCOM
Enable these standard U-Boot commands for image manipulation and for starting the default boot command using 'boot' command in U-Boot shell.
--- configs/stm32mp15_dhcom_basic_defconfig | 3 --- 1 file changed, 3 deletions(-)
configs/stm32mp15_dhcom_basic_defconfig +0 -3
@@ -19,10 +19,7 @@ CONFIG_SPL_MTD_SUPPORT=y CONFIG_SPL_POWER_SUPPORT=y CONFIG_SYS_SPI_U_BOOT_OFFS=0x80000 CONFIG_SYS_PROMPT="STM32MP> " -# CONFIG_CMD_BOOTD is not set # CONFIG_CMD_ELF is not set -# CONFIG_CMD_IMI is not set -# CONFIG_CMD_XIMG is not set # CONFIG_CMD_EXPORTENV is not set CONFIG_CMD_EEPROM=y CONFIG_CMD_MEMINFO=y
Signature · 1 line
2.25.1
PATCH 1/1 ARM: stm32: Enable bootd, iminfo, imxtract on DHCOM
Dear Marek,
Quoted 10 lines
From: Marek Vasut <[email protected]>
Sent: mercredi 1 avril 2020 17:13Enable these standard U-Boot commands for image manipulation and for starting the default boot command using 'boot' command in U-Boot shell.
Signed-off-by Marek Vasut <[email protected]>Cc Patrick Delaunay <[email protected]>Cc Patrice Chotard <[email protected]>---
And I think I will done the same patch on ST defconfig.
Thanks
Patrick
PATCH 1/1 ARM: stm32: Enable bootd, iminfo, imxtract on DHCOM
Quoted 8 lines · Patrick DELAUNAY
Dear Marek,
Quoted 6 lines
From: Marek Vasut <[email protected]>
Sent: mercredi 1 avril 2020 17:13Enable these standard U-Boot commands for image manipulation and for starting the default boot command using 'boot' command in U-Boot shell.
Quoted 8 lines
Quoted 4 lines
Signed-off-by Marek Vasut <[email protected]>Cc Patrick Delaunay <[email protected]>Cc Patrice Chotard <[email protected]>---
Reviewed-by Patrick Delaunay <[email protected]>And I think I will done the same patch on ST defconfig.
Yes please, without this, it was quite annoying on the stm32mp1.
PATCH 1/1 ARM: stm32: Enable bootd, iminfo, imxtract on DHCOM
In reply to Marek VasutDear Marek,
Quoted 6 lines
From: Marek Vasut <[email protected]>
Sent: mercredi 1 avril 2020 17:13Enable these standard U-Boot commands for image manipulation and for starting the default boot command using 'boot' command in U-Boot shell.
Quoted 7 lines
Signed-off-by Marek Vasut <[email protected]>Cc Patrick Delaunay <[email protected]>Cc Patrice Chotard <[email protected]>--- configs/stm32mp15_dhcom_basic_defconfig | 3 --- 1 file changed, 3 deletions(-)
Applied to u-boot-stm/master, thanks!
Regards
Patrick