board: xilinx/zynqmp: Remove 1-second delay at boot
PATCH 1/1 board: xilinx/zynqmp: Remove 1-second delay at boot
SPL boot is slow on the ZynqMP because of this delay. The initialization done in psu_init no longer requires an external delay, so this can be removed to speed up the SPL boot flow considerably.
Signed-off-by Mike Looijmans <[email protected]>
--- board/xilinx/zynqmp/zynqmp.c | 4 ---- 1 file changed, 4 deletions(-)
board/xilinx/zynqmp/zynqmp.c +0 -4
@@ -32,7 +32,6 @@#include <zynqmp_firmware.h> #include <g_dnl.h> #include <linux/bitops.h> -#include <linux/delay.h> #include <linux/sizes.h> #include "../common/board.h"
@@ -334,9 +333,6 @@ int board_early_init_f(void) ret =psu_init ();if (ret)return ret; - -/* Delay is required for clocks to be propagated */ -udelay (1000000 );#endif #ifdef CONFIG_DEBUG_UART
Signature · 1 line
2.17.1
PATCH 1/1 board: xilinx/zynqmp: Remove 1-second delay at boot
Quoted 23 lines · Mike Looijmans
SPL boot is slow on the ZynqMP because of this delay. The initialization done in
psu_initno longer requires an external delay, so this can be removed to speed up the SPL boot flow considerably.Signed-off-by Mike Looijmans <[email protected]>--- board/xilinx/zynqmp/zynqmp.c | 4 ---- 1 file changed, 4 deletions(-)board/xilinx/zynqmp/zynqmp.c +0
-1@@ -32,7 +32,6 @@#include <zynqmp_firmware.h> #include <g_dnl.h> #include <linux/bitops.h> -#include <linux/delay.h> #include <linux/sizes.h> #include "../common/board.h"
board/xilinx/zynqmp/zynqmp.c int board_early_init_f(void) · line 338
Quoted 9 lines
board/xilinx/zynqmp/zynqmp.c +0
-3@@ -334,9 +333,6 @@ int board_early_init_f(void) ret =psu_init ();if (ret)return ret; - -/* Delay is required for clocks to be propagated */ -udelay (1000000 );#endif #ifdef CONFIG_DEBUG_UART
Mike reported me that removing this 1s is causing issue in SD boot mode that's why I am not applying this patch till we root caused it.
Thanks,
Michal