configs: pico-imx6: convert ethernet function to DM_ETH
PATCH v2 1/1 configs: pico-imx6: convert ethernet function to DM_ETH
From: Wig Cheng <[email protected]>
Before enable _DM_ETH:
Net: FEC [PRIME]
After enable DM_ETH:
Net: eth0: ethernet at 2188000
Here is the test commands:
=> dhcp
BOOTP broadcast 1
DHCP client bound to address 10.88.88.152 (146 ms) *** ERROR: `serverip' not set
Cannot autoload with TFTPGET
=> ping 8.8.8.8
Using ethernet at 2188000 device
host 8.8.8.8 is alive
--- configs/pico-imx6_defconfig | 2 ++ 1 file changed, 2 insertions(+)
configs/pico-imx6_defconfig +2 -0
@@ -65,6 +65,8 @@ CONFIG_DM_MMC=y CONFIG_FSL_USDHC=y CONFIG_PHYLIB=y CONFIG_PHY_ATHEROS=y +CONFIG_DM_ETH=y +CONFIG_RGMII=y CONFIG_PINCTRL=y CONFIG_PINCTRL_IMX6=y CONFIG_MXC_UART=y
Signature · 1 line
2.17.1
Fabio Estevam
reviewerPATCH v2 1/1 configs: pico-imx6: convert ethernet function to DM_ETH
Quoted 19 lines · On Tue, Jul 28, 2020 at 11:04 PM <[email protected]> wrote:
From: Wig Cheng <[email protected]>
Before enable
_DM_ETH:
Net: FEC [PRIME]After enable
DM_ETH:
Net: eth0: ethernet at 2188000Here is the test commands:
=> dhcp
BOOTP broadcast 1
DHCP client bound to address 10.88.88.152 (146 ms) *** ERROR: `serverip' not set
Cannot autoload with TFTPGET
=> ping 8.8.8.8
Using ethernet at 2188000 device
host 8.8.8.8 is alive
Quoted 1 line
Signed-off-by Wig Cheng <[email protected]>